CBT Supply FIK-19 Installationshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Installationshandbuch für Inneneinrichtung CBT Supply FIK-19 herunter. CBT Supply FIK-19 16 Seiten. Flipit kit generation ii

Seite drucken

STEP 5 -

Positioning Template

for Keyboard Tray

Pilot Holes

STEP 6 -

Make a Depth Gauge

for Drilling Pilot Holes

STEP 7 - Drilling

Pilot Holes for

Brackets

Use a power drill to make

1/8" holes 3/8" deep using

the masking tape depth

gauge you just made.

Repeat this step for the

remaining Pilot Holes.

Use a glue stick on the back of the template where holes are indicated to be dr illed.

Press the template in place, aligning centerline at front edge of desktop .

Additional guide lines on template are

provided for centered alignment.

NOTE: These illustrations show the

underside of the desktop. If you can

remove the desktop for installation,

this is recommended.

To help prevent the mistake of

drilling though your desktop, use

a depth gauge, or make one

with masking tape. Measure

3/8" from the tip of the 1/8" drill

bit to indicate the dr illing depth

for mounting bracket pilot holes.

Mark the 3/8" depth with a piece

of masking tape wrapped

around the drill bit.

With this completed, the cut-out

and pilot holes should meet

factory specifications. You are

now ready to begin installation

of the flipIT mechanism.