DUUN PA20 Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Industrielle Ausrüstung DUUN PA20 herunter. DUUN PA20 13 Seiten.

Assembly instructions

Before connecting the power transmission shaft, ensure the following points.

Make sure that the shaft's protective tubes are intact and the two halves of the shaft fit freely into

each other.

The length of the power transmission shafts must be adjusted thoroughly, if it is too long it can

damage the bearing in the tractor's PTO or the propeller's bearings. Also ensure good lubrication

of the profile pipes. Read the instruction manual for the power transmission shaft.

Check if the PTO shaft can be rotated by hand to ensure it is not buckling anywhere.

Ensure that all shaft covers are in good condition and correctly fitted. Never start the machine

without this being in order! Pay particular attention to the plastic covers on the power transmission

shaft. If these are damaged, they must be replaced immediately! The locking chains for the plastic

covers must always be attached to suitable fasteners on the mixer to prevent the covers from

rotating. The covers are lubricated according to the specified interval.

Mount the PTO shaft on the tractor's PTO with the shear bolt coupling against the propeller

agitator. The wide-angle joint on the shaft must face the tractor. Safety chain is attached to the

propeller to prevent rotation of protective covers.

The power transmission shaft must always have a shear bolt coupling max. 4180 nm.

Check that the power transmission shaft will not sit in tension when the machine is lifted to the

max. or min. height. Also, note, the angle of the shaft can be too large when using very short

shafts - contact the supplier - importer.