DUUN 03001 Gebrauchsanweisung - Seite 14

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Schneefräse DUUN 03001 herunter. DUUN 03001 16 Seiten.

Service and maintenance

Before cleaning, lubricating, repairing or adjusting the machine, stop the engine and activate the

handbrake, and remove the key during work.

Pay special attention to safety during maintenance work, park the machine in according with

specified safety rules.

Inspection after screw connections

Screws - nuts - fittings and bolts on the machine should be re-tensioned after two hours of

operation. All moving parts should be lubricated with grease.

The ejector spout's swivel is exposed to both cold and heavy wear - therefore use cold-resistant

grease that can handle up to -40 degrees. Points 4 and 5.

Wear steel and skid pads are exposed to heavy wear - check and carry out the replacement or

reversal of wear steel before damage occurs to the hull itself and mounting brackets.

Replacement of feeder blade – replacing the feeder blade, the opposite blade must be replaced

also at the same time to stop vibrations.

Remove snow after use so that icing does not cause any problems at start-up later.

To extend the life of the machine, cleaning after use is recommended.

Do not flush water directly into the bearing. For long-term storage, it is recommended to lubricate

the machine in acid-free oil.

Interval of lubrication and grease quality

1. Bearings for the main axle in front of fan

Interval:

Monthly and when parking in the spring (approx. every 200 hours).

Avoid pushing in too much grease as this can cause sealing rings to squeeze out +

contribute to overheating of the entire bearing.

Recommended amount of 7-8 grams per time.

2. Lagere for hovedaksling og flenslager bak

Interval:

Monthly and when parking in the spring (approx. every 200 hours).

Avoid pushing in too much grease as this can cause sealing rings to squeeze

out + contribute to overheating of the entire bearing.

The recommended amount of 7-8 grams per time.

3. Expiration spout for ball bearing

Interval:

Every 50 hour.

4. Sprocket on outlet spout

Interval:

When needed.

5. Power transmission shafts – universal joint + telescopic tube

Every 8 – 10 operating hour.

Interval:

Maintained according to the attached instruction manual. Please contact the supplier if this is

missing.

Grease quality: Universal grease of good quality.