Dux ProFlo 125T118 Benutzerhandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Warmwasserbereiter Dux ProFlo 125T118 herunter. Dux ProFlo 125T118 16 Seiten. Electric storage water heaters
Auch für Dux ProFlo 125T118: Benutzerhandbuch (16 seiten), Benutzerhandbuch (16 seiten)

Seite drucken

General:

This water heater is designed for single phase

230 - 240V a.c. supply only. The electrical

connection must comply with Local Supply

Authority Regulations and AS/NZS 3000.

Connection of the electrical wiring must only be

carried out by a licensed tradesperson.

Connections are made at the terminal block

under the water heater electrical cover. A means

for disconnection must be incorporated in the

fixed wiring in accordance with the Wiring Rules.

Removing the Electrical Cover:

Before removing the electrical cover, ensure the

electrical power supply is safely isolated.

The electrical cover is removed by undoing

the two screws at the bottom of the cover and

sliding the cover downwards to disengage the

top edge.

Connections:

The cable entry is a pre-punched hole designed

to accept a 20 mm conduit gland. It is located

adjacent to the terminal block.

To prevent damage to the wiring, the cable entry

must be fitted with a gland prior to feeding the

wiring through the hole. Ensure the conduit entry

is sealed correctly.

H0421

0421

Rev. R

Owner's Manual – Proflo Electric Storage Water Heaters

Electrical Connection

Connect the active and neutral wires to the

terminal block and the earth wire to the earth tab

(located on the right hand side). Excess wire is

not to be looped close to the thermostat or tank.

Replacing the Electrical Cover:

Press the reset button on the thermostat to

ensure the over-temperature energy cut-out

is set.

If supplied inside the electrical cover, ensure

that the Pressure & Temperature Relief

Valve, both of the brass plugs, and their

clear plastic packaging have been removed

from inside the cover.

Slide the cover up, ensuring the top edge

engages under the case.

Swing the cover down until the bottom

edge contacts the case. Ensure the terminal

block mounting plate is below the pins

located inside the cover.

Refit & tighten both screws in the cover.

Ensure the water heater is filled with water

before turning on the electricity supply.