Dux proflo 125X136 Benutzerhandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Warmwasserbereiter Dux proflo 125X136 herunter. Dux proflo 125X136 16 Seiten. Electric storage water heaters
Auch für Dux proflo 125X136: Benutzerhandbuch (16 seiten)
Seite drucken
INSTALLATION REQUIREMENTS
GENERAL:
This water heater must be installed by a
licensed tradesperson, and in accordance
with:
•
In Australia, the Plumbing Code of
Australia (PCA);
•
In New Zealand, Clause G12 of the New
Zealand Building Code (NZBC);
•
AS/NZS 3000 Electrical Installations
(known as the Australian / New Zealand
Wiring Rules); and
•
Local authority regulations.
Outside Australia and New Zealand, please
refer to local plumbing and building codes and
regulations.
Failure to comply with these requirements may
affect the warranty.
AS/NZS 3500.4 Plumbing and Drainage –
Heated Water Services provides a Deemed-to-
Satisfy Solution for the PCA and a Verification
Method for Clause G12 of the NZBC. Other
methods of compliance are available. Dux
recommends that installations conform with
AS/NZS 3500.4.
NOTE FOR VICTORIA:
This water heater must be installed by a
licensed person as required by the Victorian
Building Act (1993).
Only a licensed person will provide a
compliance certificate, showing that
the work complies with all the relevant
Standards. Only a licensed person will have
insurance protecting their workmanship.
iii
Owner's Manual – Proflo Electric Storage Water Heaters
Important Safety Information
LOCATION:
The water heater should be located as close
as possible to the most frequently used hot
water outlet.
Ensure the compliance plate and associated
warnings are clearly visible. The water
heater must be accessible without the use
of a ladder or scaffold. Adequate clearance
must be available for service to the element,
thermostat, relief valve and anode. All
models are equipped with a sacrificial anode,
allow half of the height of the water heater to
provide access through the top cover.
Electric storage water heaters may be
installed indoors. A properly drained safe tray
must be installed where property damage
could occur from water spillage. Refer to
AS/NZS 3500.4 for further information.
Note - the warranty will not cover damage
due to leakage of the water heater if a
properly drained safe tray has not been
installed.
Refer to local regulations before installing the
water heater in a roof space.
WATER HEATER SUPPORT:
The water heater must be installed on a flat,
solid supporting surface. The pipework must
not be used to support the water heater.
Where the water heater is subjected to wet
conditions, a plinth should be installed under
the water heater.
POOL HEATING:
This water heater must not be used for pool
heating.
H0421
0421
Rev. Q