DV Mark Galileo 15 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Musikinstrumenten-Verstärker DV Mark Galileo 15 herunter. DV Mark Galileo 15 13 Seiten.

FRONT PANEL

1) INPUT Connect your guitar to this input using a standard ¼" shielded instrument cable.

2) BRIGHT This switch boosts the upper frequencies, adding brightness to your sound. This is often used to compensate for the loss of

brightness that occurs when the amp is being used at low volumes.

3) GAIN This knob sets the gain level, and is the preamp's most powerful control. It not only determines the amount of drive or saturation (for

getting clean, crunch or overdriven sounds, or anywhere in between), but also plays an important role in tone shaping.

4) BASS This knob controls the amount of low frequencies in your sound. When you're starting to explore sounds on the amp, avoid boosting

the lows too much as this can reduce your attack and muddy your sound—especially as you turn up your gain.

5) MIDDLE The Middle control regulates the midrange frequencies and is an important part of your tone shaping. The frequency range it

boosts or cuts has a big effect on the character of your sound. For a more scoopy tone, lower the mids. Turn the knob up for more focused

attack and better pitch definition.

6) HIGH The High knob controls the amount of high frequencies in your sound. It can produce unwanted noise (hiss) or pickup feedback when

really cranked, so it's best to avoid extreme settings.

7) MASTER This control is the master feed from the end of the preamp channel to the tube power stage. It allows you to obtain a wide range

of sounds/colours in relation to the gain setting—for example, very low gain sounds at high volumes, or high gain sounds at low volumes.

8) POWER This switch delivers AC power to the amp. Make sure the unit is grounded; all three terminals of the AC power plug must be

connected to avoid any injury to the user or damage to the unit. DV Mark amps and combos are manufactured to be used in the country

where they have been sold, and are factory preset to that country's voltage. So make sure you're sending the correct voltage to your amp

before you connect it to AC power.