DV Mark Little 40L6 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Musikinstrumenten-Verstärker DV Mark Little 40L6 herunter. DV Mark Little 40L6 13 Seiten.

Seite drucken
the tubes to heat up before turning on the plate voltage. The "power on" LED will flash for 30 seconds before the amp is ready. When the LED
stops blinking, flip the standby switch to the ON position. Between sets or whenever you're on a break from playing, put the amp in standby
position (down).
12) POWER This switch delivers AC power to the amp. Make sure the unit is grounded; all three terminals of the AC power plug must be
connected to avoid any injury to the user or damage to the unit. DV Mark amps and combos are manufactured to be used in the country where
they have been sold, and are factory preset to that country's voltage. So make sure you're sending the correct voltage to your amp before you
connect it to AC power. Follow the procedure described in the STANDBY section above (11) before powering up your amp.
3
2
10
11
1
12
4
5
6
7
8
9
5