Convoy Technologies RVM-0732 Handbuch für Besitzer und Installation - Seite 4
Blättern Sie online oder laden Sie pdf Handbuch für Besitzer und Installation für Zubehör für Kraftfahrzeuge Convoy Technologies RVM-0732 herunter. Convoy Technologies RVM-0732 6 Seiten. Rearview mirror monitor
Seite drucken
Owner's / Installation Manual
Performance Series
Mounting the RearView Mirror Monitor
1) Loosen the set screw holding the installed rearview mirror in place, and carefully slide it off its base. The Convoy RVM-0732
will use the installed base on the windshield.
2) Mount the supplied windshield bracket to the back of the RVM-0732 with the supplied screws. Slide the bracket onto the base
on the windshield, tighten the locking screw. Route the cable up under the headliner to the A pillar and down.
3) The device may be powered by a 12 or 24 volt automotive battery or vehicle electrical system.
4) Make sure all cables are connected properly, observe polarity. Improper cable connections may damage the monitor. Remove
the power cable connections when you do not intend to use the unit.
Function Keys:
1.
Power = Power On/Off
2.
= a. Vol Down
b. Adjust up numbers of options in menu pages
3.
MENU = a. Enter Menu
b. Turn Menu Page
4.
= a. Vol Up
b. Adjust down numbers of options in menu pages
5.
AV
= a. Single channel switch (AV1, AV2)
b. As option choosing button in menu page
Please read this manual thoroughly before operating the unit, and keep it for further reference.
Convoy Technologies 6409 Highview Drive | Fort Wayne, IN 46808 | Ph (888) 565-2583
RVM-0732
1. AV2 Camera Trigger Wire—Green
2. Red to Power (9-48VDC +)
3. Black to Ground
4. 13 pin din to Monitor
5. AV1-AV2 , 4 pin din to Cameras