Aussie Scud 351 Handbuch für Betrieb und Wartung - Seite 3
Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Hochdruckreiniger Aussie Scud 351 herunter. Aussie Scud 351 13 Seiten. Aussie scud series
Auch für Aussie Scud 351: Betriebsanleitung (16 seiten)
Seite druckenFeb 2012
ASSEMBLY AND PREPARATION FOR USE
Before proceeding with assembly of your new Aussie Eco AB high pressure blaster, check that all parts listed
below are included.
1 Gun handle assembly and high pressure hose
1 Lance and nozzle assembly
A.
Machine Preparation (initial start-up)
1.
Check the oil in the pump and gearbox.
Note separate reservoirs. With the machine on a level surface the oil
lever should cover the red spot in the oil level sight glass on the side
of the machine. If necessary, top up with SAE 75W-90. Do not mix
different grades of oil as this may affect the machines performance.
If alternative oil is used, first empty out oil by unscrewing drain plug
in bottom of machine.
2.
Ensure breather plug is fitted to pump.
WARNING: Before operation ensure top mounted travel plug is
replaced by breather plug. Failure to fit breather and keep clean can
result in over pressuring of oil chamber (crank case) and can blow oil
seals. This will void warranty.
3.
Note that the gearbox has a separate oil reservoir. Gearbox oil is
SAE 90 gear oil.
4.
Connect battery leads on electric start machines.
5.
Check oil level in engine and fill with proper grade oil if necessary.
(SAE 10W-30 for Honda engines, check engine manual for other
makes)
6.
Check fuel level and fill if necessary. (unleaded petrol)
7.
Assemble gun/lance assembly.
HEAVY DUTY LANCE: To assemble the lance, insert Section B into Section A and screw together and check
nozzles have been fitted to end of lance (C & D).
Aussie Safety Protection Kit
Detergent injector
HP hose
connection
Supply hose
connection
Unloader - factory set,
DO NOT adjust
Aussie Scud & Ultra ... Operation & Maintenance Manual
A
Aussie Pumps
Breather plug
B
Safety valve
Thermal dump
C
D
3