Aussie eCigs Ego-O Unterweisung und Wartung

Blättern Sie online oder laden Sie pdf Unterweisung und Wartung für Elektronische Zigaretten Aussie eCigs Ego-O herunter. Aussie eCigs Ego-O 3 Seiten.

Ego-O Instructions and Maintenance
For safe and effective use of the product, please read through the following information carefully before use.
Your Starter Kit contains:
 - 1 x Large eGo Case
 - 2 x eGo-O 1100mah Batteries
 - 2 x CE4+ Atomizers
 - 1 x Juice bottle with Needle
 - 1 x USB Charger
 - 1 x AC Adapter (240VAC AU/NZ)
CHARGING:
TIP: First Time Charge :
Fully charge your eGo batteries for a full
EIGHT HOURS BEFORE USE.
Remove the AC Adapter from the kit and plug into the wall.
Plug the USB charger  into the AC Adapter. Gently screw the battery  into the USB Charger fitting but
DO NOT OVER TIGHTEN!
With the AC power on, the blue light on the battery illuminates when the battery is sufficiently tight and is
now charging. The light on the USB Charger will initially illuminate RED and will change to GREEN when
charging is complete. For the first charge, please wait the recommended eight hours before removing
your battery from the charger in order to gain the best future performance.
In order to get maximum performance from the eGO-O batteries, it is recommended that you do not
recharge a partially flat battery. Charge only when a battery is completely flat and the blue LED flashes.
Each battery can be recharged approx. 300 times. As the battery gets older it will loose charge more quickly.
When the battery will not hold charge for a satisfactory period of time it will need to be replaced.
Do not use your charger in damp areas or near a high temperature heat source or heater. Do not open or
pierce the AC Adapter or USB charger. If the AC Adapter or USB Charger is found to be emitting any odour or
excessive heat or is discoloured or deformed please disconnect from the power and discontinue use.
Please keep your eGo eCig batteries and atomizer out of the reach of children and animals.
ASSEMBLY:
Once the LED light on the charger turns GREEN your battery is fully charged and can be attached to the
Atomizer(3) for use. GENTLY screw the top of the battery into the base of the Atomizer – DO NOT OVER
TIGHTEN.
V1.0 (Sep 2013)
Page