Agri-Fab 45-02153 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Streuwagen Agri-Fab 45-02153 herunter. Agri-Fab 45-02153 12 Seiten. 100 lb. tow broadcast spreader

Seite drucken

assemBlY InsTruCTIons

Tools reQuIreD For assemBlY

(1) Pliers

(2) 7/16" Open or Box End Wrenches

(2) 1/2" Open or Box End Wrenches

(1) Small Hammer

1. Remove the spreader, loose parts and hardware package

from the carton. Lay out all parts and hardware and

identify using the illustrations on pages 2 and 3.

2. Turn the spreader upside down as shown in figure 1,

so that it rests on the hopper.

FIGure 1

3. Remove the lock nut from the middle bolt in the crossover

tube and shaft support plate. Leave the bolt in place.

See figure 2.

4. Assemble the short end of the hitch tube onto the middle

bolt and secure it with the same lock nut you removed.

Do not tighten at this time. See figure 2.

ImPorTanT: The hitch tube must attach to the side of the

crossover tube opposite the shaft support plate.

5. Assemble the two hitch braces to the inside of the hopper

frame, one on each side, using two 1/4" x 1-3/4" hex

bolts and two 1/4" nylock nuts. See figure 2. Do not

tighten at this time.

6. Assemble the two hitch braces to the hitch tube using a

1/4" x 1-1/2" hex bolt and a 1/4" nylock nut. See figure

2. Do not tighten at this time.

MIDDLE BOLT

HITCH

TUBE

1/4" x 1-1/2"

HEX BOLT

HITCH BRACE

FIGure 2

7. Tighten all hex nuts and bolts, following the same

sequence as assembled in steps 4, 5 and 6. Do not

collapse tube when tightening.

8. Assemble a spacer and then a 1/2" flat washer onto

each end of the axle. See figure 3.

FIGure 3

SHAFT

SUPPORT

PLATE

CROSSOVER

TUBE

1/4" NYLOCK

NUT

HITCH BRACE

AXLE

1/2" DIA.

FLAT WASHER

MIDDLE

LOCK NUT

SPACER