4O3A Rotator Genius Handbuch - Seite 16

Blättern Sie online oder laden Sie pdf Handbuch für Controller 4O3A Rotator Genius herunter. 4O3A Rotator Genius 20 Seiten.

Device selection

This is how your window looks like when you first open

the application. You first need to add your device to the

list.

Press the

button to add.

The button to its right is the edit button, and finaly delete.

Adding the device

Press Save when done.

RG Control Panel

This is the RG Control Panel. You can see your status and

send commands from here.

It is recommended configure your rotators before

attempting to move them.

Click the settings icon on the top of the window.

⬆

Back to table of contents

Add device

Name your device and enter its IP address and port

number.

Check how to set your IP address and port number in the

NETWORK SETTINGS section above.

Connect

Select your rotator from the list, and click Connect.

Rotator configuration

Name your rotator, and set the limits if you do not want

your rotator to go beyond a certain point.

You will not be able to give it a target beyond the limits.

However, if external factors move the antenna out of

bounds, you will be able to use the CW and CCW buttons

to move it back to the allowed aria.

In case your rotator has some inertia when stopping, you

can compensate by adding the offset. This will stop the

rotator the amount of set degrees before its final location.

Click Save when done.

Page 16