Aussie Pumps AB Scud 40 Betriebsanleitung - Seite 4
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Hochdruckreiniger Aussie Pumps AB Scud 40 herunter. Aussie Pumps AB Scud 40 16 Seiten. Stainless steel frames, 3,000/4,000 psi
Auch für Aussie Pumps AB Scud 40: Betriebsanleitung (16 seiten)
Seite druckenAussie Pumps
ASSEMBLY AND PREPARATION FOR USE
Before proceeding with assembly of your new Aussie
AB Scud Cadet high pressure blaster, check that all
parts listed below are included.
1 x Gun handle assembly
1 x High pressure hose
1 x Lance and nozzle assembly
1 x Foamer (AB30 Hose reel version only)
A.
Machine Preparation (initial start-up)
Breather plug
Pump oil level
1. Check the oil in the pump.
With the machine on a level surface the oil lever
should cover the red spot in the oil level sight
glass on the side of the machine. If necessary, top
up with SAE 75W-90. Do not mix different grades
of oil as this may affect the machines
performance. If alternative oil is used, first empty
out oil by unscrewing drain plug in bottom of
machine.
2. Ensure breather plug is fitted to pump.
WARNING: Before operation ensure top mounted
travel plug is replaced by the yellow breather
plug. Failure to fit breather and keep clean can
result in over pressuring of oil chamber (crank
case) and can blow oil seals. This will void
warranty.
4
Aussie AB Scud Cadet Series ... Operation & Maintenance Manual
3. Check oil level in engine and fill with proper
grade oil if necessary. (SAE 10W-30 for Honda
engines, check engine manual for other makes)
4. Check fuel level and fill if necessary. (unleaded
petrol)
5. Assemble gun/lance.
6. Fit hose reel to frame (purchased separately)
Fitting instructions for optional hose reel (AB40 only)
Securely clamp the hose reel mounting bar across
the top of the Scud frame using the two sets of
nuts and bolts supplied (AB40 only). Aussie Pumps
recommends using Loctite on the bolts to prevent
them vibrating loose.
Fit hose reel to the mounting bar using the four
sets of nuts and bolts supplied. Ensure all bolts are
securely tightened and use Loctite to prevent
them vibrating loose.
The reel should be positioned so that it rotates
fore/aft to aid fitting whip hose.
March 2018