Datavideo DAC-2 Installationshandbuch - Seite 8

Blättern Sie online oder laden Sie pdf Installationshandbuch für Medienkonverter Datavideo DAC-2 herunter. Datavideo DAC-2 13 Seiten. Important note to make dac-2/dac-100 work with pinnacle dv500
Auch für Datavideo DAC-2: Handbuch zur Schnelleinrichtung (6 seiten), Ergänzendes Handbuch (5 seiten), Ergänzendes Handbuch (13 seiten)

Seite drucken

Switching DAC-2 Modes

The DAC-2 with Version 4.8 software (Please check your serial number sticker on

the bottom of your DAC-2 for a version number stamping or label) can be switched

into 3 modes :

Mode 1 Default is the Windows 2000 mode

(This mode is primarily for Windows 2000 users.)

Please Note: The DAC-2 will always default to this mode on power up.

Mode 2 is a secondary mode that works well with MACs (running OS X) and

windows

Mode 3 is a general setting for other DV devices (Cameras, etc.)

To cycle through each mode please do the following:

To go to mode 2, press and hold the encode button for about 3 seconds.

The 12 bit and 16 bit encode LED's will alternate as a confirmation.

To go to mode 3 press and hold the encode button again for about 3 seconds. The

CV and S/YUV LED's will alternate as a confirmation.

If the encode button is pressed and held again the DAC-2 will go back into its initial

"default mode". This is confirmed with the 12bit and 16 bit encode LED's staying

light for about 2 seconds.

Mac Users

When you connect it with your Mac please put the DAC-2 into mode 2 before

connecting it to the Macs FireWire Port.

Please Note: If the DV button is pressed, the DAC-2 will then be reset to the

default Windows 2000 Mode.