Cook & Beals Spin-Float Honey-Wax Separator Anweisungen - Seite 2
Blättern Sie online oder laden Sie pdf Anweisungen für Landwirtschaftliche Geräte Cook & Beals Spin-Float Honey-Wax Separator herunter. Cook & Beals Spin-Float Honey-Wax Separator 5 Seiten. Replacing separator belts
Seite druckenInstructions for replacing separator belts
1.
Loosen cutter belt tightener (see 1A).
2.
Loosen drum belt tightener bolts 1 & 2 (see 1A-C & 2A-C).
3.
Loosen all 4 motor belt tightener bolts (see 1A).
4.
Remove worn belts:
a. Motor belt #6941 (see 1A)
b. Drum belt # 6944 (see 2A-B)
c. Cutter belt #6937 (see 3A-B)
5.
Install new belts:
a. Cutter belt #6937 (see 3A-B)
b. Drum belt #6944 (see 2A-B)
c. Motor belt #6941 (see 1A)
6.
Drum belt tightener bolt #1 should be slightly more than finger tight
(see 1A-C & 3A-B).
7.
Tension drum belt by tightening drum belt tightener bolt #2 (see 1A-C
& 3A-B).
8.
Once the drum belt is tight, tighten drum belt tightener bolt #1 (see
2A-C).
9.
Tighten the cutter belt with the cutter belt tightener rod (see 1A & 2A-
C).
10.
Tighten the motor belt by pushing the motor outward with the 4 motor
belt tightener bolts. The motor plate should be equal measurements
on all 4 corners when measured from the separator base plate (see
1A).
DISCLAIMER: These photos may not apply to some older separators.
Please call (308)745-0154 CST if you need further assistance.