Frigidaire Designer Series Benutzerhandbuch - Seite 4

Seite drucken

Frigidaire Designer Series Benutzerhandbuch

IMPORTANT SAFETY INSTRUCTIONS(coo,,o o )

• Placement

of Oven Racks. Always place oven racks in desired

location while oven is cool. Remove all utensils from the rack before

removing rack. If rack must be moved while oven is hot, use extreme

caution. Use pot holders and grasp the rack with both hands to

reposition. Do not let pot holders contact the hot oven element or

interior of the oven.

• Donotuse thebroilerpan

withoutitsinsert.

The broiler pan and

grid allow dripping fatto drain and be kept away from the high heat

of the broiler.

• Do not cover the broiler

grid or oven bottom

with aluminum

foil. Exposed fat and grease could ignite.

• Cleaners/Aerosols--Always

the

manufacturer's

recommended directions for use. Be aware that excess residue from

cleaners and aerosols may ignite causing damage and/or injury.

SELF CLEANING OVENS:

• Clean in the self-cleaning cycle only the parts of the appliance

listedin this Owner's Guide. Before using the self-cleaning cycle

of the appliance, remove the broiler pan and any utensils stored in

the appliance.

• Do notclean

the oven doorgasket.

The door gasket is essential

for a good seal. Care should be taken not to rub, damage or move

the gasket.

• Do not touch a hot oven lightbulb with a damp cloth. Doi ng so

could cause the bulb to break. Disconnect the appliance or shut off

the power to the appliance before removing and replacing the

bulb.

• Do notuse oven cleaners. No oven cleaner or oven liner protective

coating of any kind should be used in or around any part of the

appliance

IMPORTANT

INSTRUCTIONS

FOR CLEANING YOUR OVEN

• Clean the appliance regularly to keep allparts

free of grease

that could catch fire. Exhaust fan ventilation hoods and grease

filters should be kept clean. Do not allow grease to accumulate.

Greasy deposits in the fan could catch fire. Refer to the hood

manufacturer's

instructions for cleaning.

SAVE THESE INSTRUCTIONS

Before Setting

Oven Controls

Oven Vent Location

The oven is vented at the upper controlpanel

or at the center trim. When the oven is on, warm

air is released through the vent. This venting is necessary for proper air circulation in the oven and

good baking results.

Arranging

Oven Racks

ALWAY5 ARRANGE OVEN RACK5 WHEN THE OVEN 15 COOL (PRIORTO OPERATING THE OVEN).

Always use oven mitts when using the oven.

To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and slide out.

To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front of the rack

upward and slide the rack back into place.

Some models have an offset rack. The rungs on the offset rack are slightly raised from the edges

of the rack. This raised part of the rack is designed to allow easy and safe removal of foods from the

lower racks of the oven and prevent hands from contacting the hot oven door. Always use the offset

rack in the lower position.

Setting

Oven Controls

For oven settings, refer to the timer section or the electronic oven control.