Agri-Fab 45-0260 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Rasen- und Gartengeräte Agri-Fab 45-0260 herunter. Agri-Fab 45-0260 16 Seiten. 42 heavy duty lawnsweeper

Seite drucken
If your tractor hitch has 8" to 10" ground clearance,
use the instructions below to assemble the sweeper
hitch brackets. If your tractor hitch has more than 10"
ground clearance, refer back to page 5.
7. Assemble the bent hitch bracket to the bottom and the
straight hitch bracket on top of the hitch tubes. Fasten
with two 5/16" x 2-1/4" hex bolts and two 5/16" hex lock
nuts as shown in fi gure 4. The bolts should straddle the
front hitch tube bolt. Do not tighten yet.
8. At this time tighten the four bolts fastening the hitch
tubes to the sweeper housing. Next, tighten the two
bolts fastening the hitch tubes together. Finally, tighten
the two bolts fastening the hitch brackets to the hitch
tubes.
9. Assemble the hitch pin, two 3/4" spacers and the
1/8" hairpin cotter to the hitch brackets. See fi gure 4.
5/16" x 2-1/4"
HEX BOLT
HITCH PIN
HITCH
BRACKET
(STRAIGHT)
3/4" SPACERS
HITCH
BRACKET
HAIRPIN COTTER
FIGURE 4
5/16" HEX
LOCK NUT
10. Assemble the height adjustment handle to the height
adjustment tube using the curved bolts, washers and
nuts which come pre-assembled to the tube. Tighten the
height adjustment handle so that the height adjustment
strap is aligned with the outside of the handle. See fi gure
5.
11. Assemble the grip onto the end of the height adjustment
handle as shown in fi gure 5.
HEIGHT
ADJUSTMENT
HANDLE
BOWED
WASHER
HEIGHT
ADJUSTMENT
TUBE
FIGURE 5
12. Place the 5/16" tooth-lock washer between the height
adjustment handle and the height adjustment strap.
Insert the 5/16" x 3/4" carriage bolt through the handle,
the tooth-lock washer and the strap. Assemble the 5/16"
Std. Wrt. washer and the plastic knob onto the end of
the bolt and tighten. See fi gure 6.
HEIGHT
ADJUSTMENT
HANDLE
HEIGHT
ADJUSTMENT
STRAP
5/16" FLAT
WASHER
(STD. WRT.)
FIGURE 6
6
GRIP
5/16" LOCK
WASHER
5/16" HEX NUT
1/4" HEX NUT
5/16" x 1-5/8"
CURVED
HEAD BOLT
5/16" x 3/4"
CARRIAGE BOLT
5/16" TOOTH
LOCK WASHER
KNOB