Agri-Fab Platinum 45-0550 Montageanleitung Handbuch - Seite 7
Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Rasen- und Gartengeräte Agri-Fab Platinum 45-0550 herunter. Agri-Fab Platinum 45-0550 16 Seiten. Leaf blade
Seite drucken
STeP 7:
(See fIGURe 7)
• With the second assembled frame lying flat and the
greater angle to the left, place a pusher wall (8) on top
with the stitching facing the frame.
• Align the pusher wall holes with the holes in the frame
and attach using six hex bolts (S), washers (G), and
hex nuts (H) in the holes shown.
• Make sure the two hex bolts on the vertical part of the
frame are on the side with the greater angle as shown.
• Tighten the six hex nuts.
• Add an acorn hex nut (T) to each hex bolt and tighten.
This is now the left pusher wall assembly with the hex
bolts at the top.
Top
View
8
aTTaCH THe Leaf RakeS TO THe PUSHeR
WaLL aSSeMBLIeS
STeP 8:
(See fIGURe 8)
• With the right pusher wall assembly lying flat, attach a
leaf rake (9) to the bottom of the pusher wall assembly
using two hex bolts (F), and hex nuts (H).
• Select the holes in the leaf rake (9) that works best for
your tractor height.
• Make sure the hex bolts secure the pusher wall fabric.
• Tighten the hex nuts (H).
• Add a second hex nut (H) to each bolt and tighten.
• Repeat step 8 with a leaf rake (9) and the left
pusher wall.
S
G
H
T
fIGURe 7
F
9
F
H
H
fIGURe 8
aSSeMBLe aNd aTTaCH THe WHeeLS
STeP 9:
(See fIGURe 9)
• Attach the wheel (10) to the bottom hole in a wheel
support (11) using a hex bolt (I), two step bushings (J),
a washer (K), and a hex nut (L).
• Tighten, but not too tight. The wheel should rotate
easily.
• Repeat with the second wheel and wheel support.
11
K
L
STeP 10:
(See fIGURe 10)
• With the right pusher wall assembly lying flat, attach
a wheel support (11) to the assembly using two hex
bolts (M), washers (G), and hex nuts (H).
• Make sure the wheel support is attached to the side of
the pusher wall assembly with the greater angle.
• Make sure the hex bolts secure the pusher wall fabric.
• Tighten the hex nuts (H).
• Add a second hex nut (H) to each hex bolt and tighten.
• Repeat step 10 to attach the other wheel support to
the left pusher wall assembly.
7
10
J
J
fIGURe 9
M
G
11
fIGURe 10
I
H