Austral Lock HD16S plus Montageanleitung

Blättern Sie online oder laden Sie pdf Montageanleitung für Schlösser Austral Lock HD16S plus herunter. Austral Lock HD16S plus 3 Seiten.

Seite drucken

HD16 PLUS

Fitting instructions

46 mm

10 mm

46 mm

Figure 1

Product code

[A]

HD16Hplus

610 mm

HD16Lplus

766 mm

HD16Pplus

313 mm

HD16Splus

313 mm

Tolerance +/- 2 mm

75 mm

[A] +/- 2mm

COUPLER

HOOK THE DRIVE BOX

ONTO THE LOCK BODY

[B] +/- 2mm

MAIN BEAK

75 mm

PUSH LOCK TO THE SIDE WHEN

FITTING THE TOP REMOTE

[B]

790 mm

634 mm

1079 mm

331mm

Door Cutout (Figure 1)

Prepare the cutouts in the section using the diagram and chart.

NOTE: ADHERE TO THE DIMENSION TOLERANCES

Installing the BOTTOM Lock (Figures 2 & 3)

Attach the bottom lock assembly drive box to the HD8 centre

lock, ensure the coupler fits over the location pins (Figure 2).

NOTE: place a support directly beneath the couple and slide.

Fasten the coupler in place doing both or either of the following:

Fit the #6x6mm screw supplied (if applicable).

Firmly rivet over both location pins.

Unlock the lock by pressing on the rocker arm and pulling the

slide down from the centre lock until it stops (Figure 3).

NOTE: to assist in preventing locking while assembling, retract

the main beak.

Select the bottom lock/centre lock assembly. Slide it down into

the section via the centre lock cutout, leaving the centre lock out of

the section.

Installing the TOP Lock (Figures 4 & 5)

While holding the centre lock aside, slide the top lock into the

section and hook the drive wire into the remaining wire hole in

the drive box coupler (Figure 4).

Carefully guide the whole assembly into the section, then using a

screwdriver, clip the collar lugs into the drive box. (Figure 5

over page)

NOTE: Ensure that the collar lugs are firmly in place.

COUPLER FIXING SCREW

COUPLER/SLIDE LOCATION PIN X 2

HD8 CENTRE LOCK

Figure 4

FIT THE TOP REMOTE

DRIVE WIRE TO THE

REMAINING WIREHOLE

DRIVE BOX

BOTTOM LOCK ASSEMBLY

Figure 3

PRESS THE ROCKER

ARM DOWN

RETRACT MAIN BEAK

TO ASSIST INSTALLATION

PULL THE

SLIDE DOWN

SLIDE THE BOTTOM LOCK

ASSEMBLY INTO THE

SECTION FIRST

Figure 2

HD16 Plus Instructions 04.cdr