AUSTRALIAN MONITOR XRS10 P Installations- und Betriebshandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Redner AUSTRALIAN MONITOR XRS10 P herunter. AUSTRALIAN MONITOR XRS10 P 13 Seiten. Powered and passive loudspeakers xrs series
Seite drucken
XRS REAR PANEL POWERED VERSION
7
10
2
1
3
5
15
PAGE 6
8
11
4
9
12
6
13 14
1
Mic In
This is a balanced XLR microphone input.
2
Mic Signal
This is a green LED signal present indicator
for the Mic input. It indicates signal present
on the input and is not affected by the level
control.
3
Line In
This is a balanced XLR line level input.
4
Line Signal
This is a green LED signal present indicator
for the Line input. It indicates signal present
on the input and is not affected by the level
control.
5
Line Out
The LINE OUT is on an XLR connector.
This output can be connected to the LINE IN
on another XRS Powered speaker to expand
the system.
6
Output Clip
This is a red LED clip indicator for the mixed
mic and line audio signal. Some flashing of
red is acceptable on program transients.
Continuous flashing of red could be placing
undue stress on the speaker and will sound
distorted. Turn down the input level until the
clip LED is no longer lit.
7
Mic Level
This controls the level of the MIC input (1).
8
Mic Bass
This is the bass control for the MIC input (1).
There is 12 dB of cut and boost at 100 Hz.
This EQ is the shelving type.
9
Mic Treble
This is the treble control for the MIC input
(1). There is 10 dB of cut and boost at
10 kHz. This EQ is the shelving type.
10
Line Level
This controls the level of the LINE input. (3)
11
Line Bass
This is the bass control for the LINE input
(3). There is 12 dB of cut and boost at
100 Hz. This EQ is the shelving type.
12
Line Treble
This is the treble control for the LINE input
(3). There is 10 dB of cut and boost at
10 kHz. This EQ is the shelving type.
13
Power Switch
This switch turns the power on or off to
the unit.
14
IEC Mains Input Socket
This is a standard IEC 3 pin socket.
It accepts a standard IEC mains cable,
(provided). The fuse drawer contains the
mains fuse and a spare.
The mains fuse is a time lag (slow blow)
HRC 20mm x 5mm ceramic or glass
type fuse.
XRS8P XRS10P XRS12P
120 V 2.5 A
2.5 A
240 V 1.6 A
1.6 A
IMPORTANT: Always replace the
fuse with one of the same value and type.
NOTE: Always disconnect power to
the amplifier before replacing fuses.
15
Voltage Select Switch
This switch is used to select the mains
voltage for your region. Select either
240 V of 120 V.
IMPORTANT: Disconnect power
to the amplifier before operating this switch.
IMPORTANT: Make sure this
setting is correct before connecting the unit
to the mains.
XRS SERIES INSTALLATION AND OPERATION MANUAL
3.15
5.0