AUSTRALIAN MONITOR AMPAV40 Installations- und Betriebshandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Lautsprechersystem AUSTRALIAN MONITOR AMPAV40 herunter. AUSTRALIAN MONITOR AMPAV40 12 Seiten. Active three way stereo speaker system
Auch für AUSTRALIAN MONITOR AMPAV40: Installations- und Betriebshandbuch (12 seiten)
Seite drucken
The AMPAV40 has a number of functions and input options which may be
selected from the active speaker's rear panel or from the supplied remote
control.
1
Control
Power:
A power LED indicator on the control panel segment indicates when power
is on (red) or when the system is in standby (orange).
Input:
Each input option is identified by an associated green LED. Selection is made
by pressing the INPUT button successive times until the required input is chosen.
Input options include; USB, Unbalanced and Balanced.
Func:
Pressing the FUNC (function) button toggles operation between the Bass,
Treble or Volume controls and the selection is indicated by a red LED. Once the
function is selected, press the "+"or "-" button successively to set the required
parameter.
2
Unbalanced Input
Unbalanced stereo RCA inputs (Left and Right) are provided for connection of
devices such as CD and DVD players, computers, data projector audio etc.
3
Balanced Input
Balanced stereo line inputs (Left and Right) are provided by 3 pin terminal
sockets and come fitted with removable screw terminal plugs. These screw
terminal inputs are high impedance and set to line level. The inputs are marked
as "+"and "-" for the incoming line and GND for the shielding ground of your
balanced cable.
NOTE: Because both the unbalanced and balanced inputs are set at
"line level" to suit most external audio sources, the inputs are not suitable for
connecting a microphone directly. This requires a suitable microphone mixer as
the output level of a microphone is considerably lower than line level sources.
AMPAV40 INSTALLATION AND OPERATION MANUAL
ACTIVE
7
5
3
2
10
AMPAV40 REAR PANEL – ACTIVE
9
8
6
4
1
4
USB
Input connection port for a USB memory stick.
Be sure to switch the INPUT to USB, a red LED indicates when USB has been
selected. Playing will start immediately after a USB stick has been inserted
into the speaker. When a USB program is being played, the red LED flashes to
indicate it is in use. Do not remove the USB stick whilst this is occurring, pause
the program or change the input before unplugging the stick to avoid damage.
The AMPAV40 is capable of playing recordings in both WMA and MP3 formats.
NOTE: The USB port is designed for USB sticks and does not support
connection of a PC or laptop.
5
USB Controls
Control buttons are provided for all the usual functions required to play ,
forward , reverse
and pause tracks on the USB stick. As this device does
not have a visual display, you should be aware of the track locations you require
when programming your USB stick.
6
Auto Standby
The Standby switch allows the system to engage the auto standby function.
AUTO mode:
In Auto mode, the speaker enters into standby (sleep) mode if no audio signal
is detected for approximately three minutes. Standby mode is identified by a
STANDBY green LED indicator on the rear panel.
The speaker will turn on automatically when it detects an audio signal and the
LED will extinguish.
OFF mode:
The "OFF" button disables the Auto mode feature.
continued over page
PAGE 5