AUSTRALIAN MONITOR ES Series Betriebshandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Mischpult AUSTRALIAN MONITOR ES Series herunter. AUSTRALIAN MONITOR ES Series 17 Seiten. Rackmount mixer
Auch für AUSTRALIAN MONITOR ES Series: Installations- und Betriebshandbuch (13 seiten)

Seite drucken

INSTALLATION

POWER REQUIREMENTS

Power consumption for your model of the ES series amplifier is indicated on the rear panel for 1/8th output power.

Ensure that your mains voltage is the same as the rear panel mains voltage marker (+/- 10%).

MOUNTING

The ES Series amplifiers are one or two rack units high (1U) (2U) and will fit a standard EIA 19" or rack.

Typically amplifiers may be stacked directly on top of each other with no need for spacing between units, unless installed in high

ambient temperature environments where a single rack unit space between amplifiers will assist cooling further.

COOLING

The mixer amplifiers are cooled by axial fans which draw air inside the amplifier and expel the heated air outside the amplifier.

An unrestricted airflow into and out from the amplifier must be provided. Any restriction of the air flow will cause heat to build up within

the unit and possibly force the unit into its thermal shutdown mode.

If the amplifiers are to be operated in an environment where the airflow is restricted such as sealed racks, cooling should be

supplemented by extra cooling fans to evacuate the heated air and aid the flow of cool air through the unit.

OUTPUT WIRING

When wiring to your speakers always use the largest gauge wire your connector will accept. The longer the speaker lead the greater

the losses which will result in reduced power and less damping at the load. We recommend using a heavy duty, two core flex (four core

flex if bi-amping) 10 to 12 gauge (2mm2 to 2.5mm2 or 50/0.25 or equivalent) as a minimum.

SPEAKER OUTPUT

The output terminal strip accepts wire sizes from 16-22AWG (1.5mm2 – 0.35mm2) or spade lugs. The following table should be used

as a guideline for cable sizes. Regulations in your area may require different gauged wire and should be checked before using.

OUTPUT

DISTANCE

100V

Upto 50m

50m - 200m

Over 200m

4 ohm

Upto 10m

10m - 30m

Over 30m

ES60

AWG26(0.12mm2)

AWG20(0.5mm2)

AWG18(0.75mm2)

AWG13(2.5mm2)

Not Recommended

ES SERIES INSTALLATION AND OPERATION MANUAL

ES120

AWG24(0.2mm2)

AWG18(0.75mm2)

AWG16(1.5mm2)

AWG18(0.75mm2)

AWG13(2.5mm2)

Not Recommended

ES250

AWG22(0.35mm2)

AWG16(1.5mm2)

AWG13(2.5mm2)

AWG18(0.75mm2)

AWG13(0.35mm2)