Australion monitor AMIS23X Installations- und Betriebshandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Crossover Australion monitor AMIS23X herunter. Australion monitor AMIS23X 10 Seiten. Stereo 2-way/mono 3-way crossover
Seite drucken3. Clip LED's
These LED's indicate that the high range or low range signals are clipping
& entering distortion. Occasional flickering of these LED's is acceptable
but if the LED remains on continuously, the level should be turned down to
avoid distortion.
4. Input Level.
This controls the input level of signal being fed to each channel.
5. Low Mute.
This switch will mute the low frequency band signal output for each
channel.
6. Low (lo) Level.
This controls the level of the low frequency band output of each channel.
7. Range Selection Switch
This switches the frequency value of the frequency control (8) from the
frequency shown on the front panel when the switch is the "off" position
to 10 x the frequency shown when in the "on" position.
8. Mid (lo/Mid) Frequency.
This will determine the crossover frequency between Low frequencies &
High frequencies for each channel when used in 2 way stereo mode. In 3
way mono mode this control will determine the (Lo/Mid) crossover point &
the corresponding Channel 2 control will determine the (Mid/Hi) crossover
point.
9. Hi Mute
This switch will mute the Hi frequency band signal output for each
channel.
10. High Level.
This controls the level of the high frequency band output of each
channel.
4