CookTek PTDS100 Benutzerhandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Küchengeräte CookTek PTDS100 herunter. CookTek PTDS100 10 Seiten. Pizza thermal delivery system

Seite drucken

ΠΡΟΕΙΔΟΠΟΙΗΣΗ: Ένα εσφαλμένα γειωμένο φις μπορεί να έχει ως

αποτέλεσμα την ηλεκτροπληξία. Παρακαλείστε να συμβουλευτείτε αρμόδιο

ηλεκτρολόγο εάν έχετε τυχόν ερωτήσεις σχετικά με αυτές τις οδηγίες

γείωσης.

Πριν ξεκινήσετε:

Βεβαιωθείτε ότι αυτό το ηλεκτρικό καλώδιο είναι σταθερά συνδεδεμένο στη μονάδα

CookTek σας ΠΡΙΝ συνδέσετε το φις της μονάδας σε ηλεκτρική πρίζα και πριν

προσπαθήσετε να θέσετε τη μονάδα σε λειτουργία.

● Μην αγγίξετε την κεραμική πλάκα (ή το άνω μέρος του Cooktop) αμέσως μετά

τη χρήση. Η θερμότητα από την κοιλότητα θα μεταφερθεί στην κεραμική πλάκα.

Ως εκ τούτου, αυτή θα είναι πολύ ζεστή για να την αγγίξετε.

● Οι εργασίες επισκευής του προϊόντος αυτού πρέπει να πραγματοποιούνται

μόνο από εξουσιοδοτημένο αντιπρόσωπο επισκευών ή από προσωπικό της

CookTek. Μην επιχειρήσετε να ανοίξετε τη μονάδα ή να εκτελέσετε οποιαδήποτε

εργασία επισκευής σε αυτήν. Για πληροφορίες σχετικά με τις επισκευές,

επικοινωνήστε με την CookTek στον τηλεφωνικό αριθμό 1-312-563-9600.

● Η συσκευή αυτή πρέπει να είναι γειωμένη. Συνδέστε μόνο σε σωστά γειωμένη

πρίζα. Πριν τη λειτουργία, διαβάστε τις οδηγίες γείωσης και τις απαιτήσεις

ηλεκτρικής εγκατάστασης στη σελίδα 3 του παρόντος φυλλαδίου. Μη

χρησιμοποιείτε καλώδιο προέκτασης (μπαλαντέζα).

Prima di mettere in funzione il piano cottura, eseguire le seguenti operazioni:

● Rimuovere tutto il materiale di imballaggio.

● Collocare l'unità su una superficie asciutta, piana, rigida, stabile e non

infiammabile.

● Tenere l'unità lontana da altre fonti di calore e lasciare almeno 5 centimetri di

spazio per consentire la circolazione dell'aria tutto intorno all'unità.

Per la propria sicurezza, non tagliare, rimuovere o disattivare mai il collegamento

elettrico di terra dalla spina. Non utilizzare mai una spina adattatore o un cavo

elettrico di prolunga per collegare il piano cottura.

AVVERTENZA: una spina elettrica non correttamente collegata all'impianto di

terra può provocare scosse elettriche. Rivolgersi a un elettricista qualificato

in caso di domande su queste istruzioni di messa a terra.

Prima di iniziare:

Assicurarsi che questo cavo di alimentazione sia collegato saldamente all'unità

CookTek PRIMA di collegare l'unità alla presa elettrica e prima di metterla in

funzione.

● Non toccare la piastra di ceramica (o la superficie del piano cottura) subito dopo

l'uso. Il calore della pentola si trasferisce alla piastra di ceramica, rendendola

estremamente calda.

ITALIAN

INSTALLATION

● The PTDS can be installed on top of, or recessed into a flat, level counter top or

shelving unit, being careful to maintain at least two inches of clearance on all

sides and six inches below the unit for cooling. (Six inches below is not

required for top of counter or top of shelf installation.)

● When installing the PTDS in a drop-in or recessed application, allow adequate

clearance for the rear air vents and power cord.

● PTDS should be plugged into a grounded outlet, single phase 120VAC or

240VAC receptacle dependant on model. Check rating plate on unit to verify

correct voltage. All models draw up to 1800W. Unit will run at voltages less

than 120VAC or 240VAC but will result in less than rated power and slower

charging times.

● If unit is dropped into an enclosed counter top, there should be an opening near

the unit for fresh air to circulate underneath.

NOTE Each PTDS should be connected to its own DEDICATED circuit. They

should not be connected to circuits sharing compressors or other heavy

current draw devices.

● Do not move the PTDS when it is electrically connected.

OPERATING INSTRUCTIONS

● Make sure that your PTDS is plugged into an energized circuit as described in

the previous section. This should be a dedicated circuit, not shared with any

devices utilizing motors, compressors, or components requiring a heavy current

draw.

● The PTDS is turned on by pressing the "POWER" button on the front of the

membrane panel. An LED will illuminate indicating that the PTDS is turned on

and ready for use.

● Place a CookTek approved bag on each PTDS.

● The red "CHARGING" LED will illuminate indicating that the bag is charging.

Do Not Remove the bag from the PTDS while the red LED is illuminated. The

bag may not fully charge resulting in a lower pizza delivery temperature.

NOTE: You will hear three loud "BEEPS" if you remove the bag before it is

fully charged.

● Pizza Bags and other objects should be removed from the PTDS overnight or if

the PTDS is not being used for an extended period of time.

● If the red "CHARGING" LED does not illuminate, remove and reposition the

bag.

● When the bag has completely charged, the green "READY" LED will illuminate

indicating that the bag is fully charged and is now ready for delivery. Charge

time for cold, or room temperature bags will be approximately two minutes.

After the first charge, recharges will take approximately 60 seconds or less,

depending on the residual energy in the bag/pellet.

● When an order is ready for delivery, remove a charged bag from andy PTDS

with an illuminated green "READY" LED.

● Immediately place another bag on the PTDS making sure that the red

"CHARGING" LED illuminates.

● Make sure that a bag is on the PTDS(s) at all times. This will ensure that all

deliveries are made with a heated bag.

Manual PTDS 10336_A USINTL