Agri-Fab 45-02212 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Rasenkehrer Agri-Fab 45-02212 herunter. Agri-Fab 45-02212 16 Seiten. 38"

Seite drucken

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1)

Screwdriver

(1)

Adjustable Wrench

(1)

9/16" Open End or Box End Wrench

(1)

1/2" Open End or Box End Wrench

Note: Right hand (R.H.) and left hand (L.H.) are

determined from the operators position while seated

on the tractor.

ASSEMBLY OF SWEEPER

1. Remove the sweeper, the loose parts and the

hardware package from the carton. Lay out the

parts and hardware as shown on pages 3 and 4.

2. Remove the 5/16" hex nuts, 5/16" lock washers

and 5/16" flat washers from the two 5/16" x 1-3/4"

carriage bolts as shown in figure 1. Assemble the

hitch tongue to the sweeper, reusing the same two

carriage bolts, flat washers, lock washers and hex

nuts. Do not tighten at this time.

SWEEPER HOUSING

5/16" x 1-3/4" CARRIAGE BOLT

HITCH TONGUE

5/16" FLAT WASHER

5/16" LOCK WASHER

FIGURE 1

3. Attach the brace rod to the square holes in the

sweeper housing using two 5/16" x 3/4" carriage

bolts, 5/16" flat washer and 5/16" hex lock nuts.

Place bolts heads on inside of sweeper housing.

Do not tighten at this time. See figure 2.

5/16" HEX NUT

FIGURE 2

NOTE: Before assembling the hitch bracket to the

hitch tongue, refer to figure 3 below and to page 10 to

determine which hitch position is required for your

towing vehicle.

4. Assemble a 3/8" x 3/4" hex bolt through the rear

hole in the hitch bracket and the hitch tongue.

Secure with a 3/8" hex lock nut but do not tighten

yet. Next, assemble the brace rod, the hitch bracket

and the hitch brace to the front hole in hitch

tongue. Secure with the brace rod clip, a 3/8" x 1-1/2"

hex bolt and a 3/8" hex lock nut. Do not tighten

yet. See figure 3.

FIGURE 3