Austro Flamm Yan Xtra Gebrauchsanweisung - Seite 7
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Herd Austro Flamm Yan Xtra herunter. Austro Flamm Yan Xtra 20 Seiten.
Seite drucken
english
1. TECHNICAL DATA
As a stove of construction type 1, it is possible to connect
it to the chimney together with an existing other stove or
another hearth for solid fuels, as long as the chimney
calculation complies with DIN 4705, Part 3.
TECHNICAL DATA
Height
Width
Depth
Weight
Weight HMS
Flue pipe outlet diameter
Nominal thermal output
Max. thermal capacity
Smallest heating capacity
2. IMPORTANT INFORMATION
The installation and operation information given here is of
general nature. National and European standards, local
and building regulations as well as fire prevention laws
must be observed during the operation of the stove.
General safety instructions for the
operation of your stove
Read the entire manual before starting up your stove
thoroughly and observe the caution notices.
Your heating unit must not be moved without approved
means
of
transport
capacity.
Your heating unit is not suitable to be used as a stand
or as a ladder.
Please keep in mind that your
stove's
surface
heats
considerably during operation.
We
therefore
recommend
wearing a safety mitten when
operating your stove.
Attention – stove varnish is no rust prevention!
Make your children aware of this particular danger and
keep them at a distance from the heating unit
whenever it is in operation.
Only burn approved fuels and materials as listed in the
chapter "Clean Burning".
The burning or placing of flammable or explosive
materials, such as empty spray cans, etc. into the
firebox as well as the storage of such materials in the
immediate vicinity of your heating unit is strictly
forbidden due to the danger of explosion.
Do not wear loose or flammable clothing when adding
fuel to the fire.
5
Yan
Ray
1480 mm
1368 mm
490 mm
634 mm
400 mm
472 mm
263 kg
327 kg
115 kg
115 kg
150 mm
150 mm
7 kW
7 kW
9 kW
9 kW
3,5 kW
3,5 kW
with
sufficient
load-bearing
up
Room heating capacity (depending on
building insulation)
Exhaust values for multiple use of the chimney in
accordance with DIN 4705, Part 3 and for the calculation
of the chimney measurements in accordance with DIN
4705, Part 2
Fluegas mass flow
Fluegas temperature
Minimum feed pressure
Nominal thermal output
Placing non-heat-resistant objects on the heating unit
or in the vicinity of the heating unit is forbidden.
Do not lay laundry onto the stove for drying. Laundry
hung up to dry must be kept at a safe distance from the
stove because of the danger of fire.
The wood stove is not suitable for long term heating.
During the operation of your heating unit it is forbidden
to use flammable or explosive materials in the same or
an adjacent room to the one in which your heating unit
is located.
The appliance must be operated with the stove door
closed.
The stove door and all fittings for adjusting the stove
must be closed, if the appliance is out of use.
Setting up your stove
Required safety distances
distances – see name plate - in Fig. 2)
a > 800 mm -
towards the front in the radiated area
– to the side
b > 100 mm
– to the back
c > 110 mm
Make sure that the room in which the stove is set up has at
least one door or window into the outside or is directly
adjacent to such a room. Other fireplaces and extractor
hoods must not be operated in the same room as the
stove.
Floor load capacity
Make sure that the load capacity of the supporting
construction is sufficient to carry the weight of the entire
unit, before the heating unit is installed.
Yan Xtra / Ray Xtra
82 – 210 m³
closed
5,4 g/s
closed
340 °C
closed
12 Pa
at 0.8 times n.
10 Pa
ther. outp.
(Minimum