BENDEL Z-011aN Original-Bedienungsanleitung - Seite 13
Blättern Sie online oder laden Sie pdf Original-Bedienungsanleitung für Farbspritzgerät BENDEL Z-011aN herunter. BENDEL Z-011aN 14 Seiten.
Seite druckenYou must observe the following points in the interest of your own safety!!!
Safety instructions:
•
When working with the FOAM-GUN, please wear protective goggles to prevent eye injuries.
•
Only use the FOAM-GUN in ventilated spaces.
•
Never operate the FOAM-GUN with more than 6.3bar.
•
Do not use cleaning agents which are acidic, alkali and/or inflammable.
We recommend the use of neutral cleaning agents.
•
When using cleaning fluids which need to be diluted, always strictly observe the
manufacturer's instructions to make sure the mixture is correct.
•
To prevent health hazards from inhalation, wear appropriate respiratory protection.
•
Never point the FOAM-GUN towards the face or body.
•
Keep the FOAM-GUN out of the reach of children.
We recommend you never clean any safety-related components, e.g. safety belts, electrical or
electronic modules, with the Z-011.
Special instructions:
The written and spoken information and recommendations which we provide to support the
purchase/user, are the result of previous experience and the latest findings. Because of the manifold
possibilities for use and processing conditions, this information is without obligation and do not
constitute a contractual legal relationship or any supplementary obligations of the sales contract.
In any event, the purchaser holds responsibility for checking suitability for the intended use himself.
Always read the safety warnings for cleaning liquids and contact the manufacturer in case of doubt.
Our liability and repsonsibility is based exclusively on our general terms and conditions of business
and are not expanded on by either this information or the technical advice of our technical field staff.
Operating instructions:
1. Remove loose soiling from the surface you wish to clean (brush or vacuum clean)
2. Turn the green rocker lever into the vertical position to activate the (cleaning) liquid in the
bottle
3. Depending on the required application pls. screw in one of the nozzles in the head of the
device.
4. Press the "trigger" all the way to foam in the surface accordingly.
5. Give the cleaner a little bit residence time but take care it will not become touch dry.
6. Afterward clean the surface with opluant water. For a optimal result we recommend to use our
TORNADOR-GUN.
Care and Maintenance
Pls. flush the head filling regular water in the cup and pressing the trigger for a while. With this
procedure you will avoid that the gaskets and filters dry out by the used cleaner when the item is not in
use.
Afterwards turn the green control switch into the horizontal "air only" position and press the trigger to
remove any remaining moisture out of the head.
Required Air Rate
To perform to its full potential, the Foam Gun requires a constant air pressure of 6 bar.
CAUTION: Constant air rates vary depending on the size and power of the compressor. Always make
sure that the tank and the air hoses are free of impurities of any kind.