Bresser TemeoTrend FSX Gebrauchsanweisung - Seite 13

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Wetterstation Bresser TemeoTrend FSX herunter. Bresser TemeoTrend FSX 16 Seiten.

7. Press CH/UP or 12/24/DOWN button to change the value.

8. Press the BARO button to save and exit the setting mode.

NOTE

9. The default relative atmospheric pressure value is 1013 mb/hPa (29.91 inHg), which refers to the

average atmospheric pressure.

10. When you change the relative atmospheric pressure value, the weather indicators will change

along with it.

11. The built-in barometer can notice the environmental absolute atmospheric pressure changes.

Based on the collected data a forecast for the weather conditions in the next 12 hours can be

made. Therefore, the weather indicators will change according to the detected absolute atmo-

spheric pressure after you operate the clock for 1 hour.

12. The relative atmospheric pressure is based on the sea level, but it will change with the absolute at-

mospheric pressure changes after operating the clock for 1 hour.

18 Connecting remote sensors

The measurements of up to 3 remote sensors* of the same type can be displayed on the weather sta-

tion's screen.

1. Remove the battery compartment cover from the remote sensor.

2. Press the CH button repeatedly until the desired channel is shown on the sensor display (CH1,

CH2 or CH3).

3. Re-attach the battery compartment cover.

4. Press the CH button on the base station repeatedly to display the measurements of the different

channels. The selected channel is shown on the display.

*one remote sensor included, more optionally available

Press °C/°F button to switch between °C or °F temperature display.

When reaching temperatures of -40°C or below, "LO" will be displayed for the respective area. When

reaching temperatures of 70°C or above, "HI" will be displayed. The temperature is below or above the

measuring range.

After returning into the measurement range, the respective temperature will be displayed again.

The base station automatically records air pressure readings from the last 24 hours.

If necessary, press the HISTORY button several times to display the history data for the hourly values

(HOUR - up to 24 hours backwards) for the pressure one after the other.

When a history date is displayed, press any key (except HISTORY) to return to the normal display

mode.

NOTICE! In the history bar graph the values for the pressure of the last 24 hours can be read at

any time in compressed form.

The main unit saves highest and lowest value records for indoor and outdoor temperature as well as

for humidity for 24 hours:

1. Press the MAX/MIN button repeatedly to display the stored values of the base station and the cur-

rently set remote sensor one after another.

13 / 16