Bender ATICS-2-ISO Series Schnellstart-Handbuch - Seite 14

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Schalter Bender ATICS-2-ISO Series herunter. Bender ATICS-2-ISO Series 16 Seiten. Automatic transfer switching devices with monitoring functions for unearthed safety power supplies - software version: d333 v1.3x, d334, v1.3x, d335 v1.0x, d308 v1.2x
Auch für Bender ATICS-2-ISO Series: Schnellstart-Handbuch (8 seiten)

Seite drucken

ATICS-2...-ISO

Press the „MENU" button to open the main menu.

• Press

to go up resp. down one menu level.

• Press

to confirm the selected menu item.

• Press „ESC" to leave the menu.

Menu overview

Main menu

Meaning

Exit

Exit menu mode

1. Alarm/ meas. val.

Displays current status messages, alarm messages and measured values

2. Changeover

Displays information on the changeover function (number, test)

3. History/Logger

Displays logger

information

4. Settings

Various settings for

the device

5. Control

Run TEST and RESET

for the device

6. Digital input

Display voltage level of the digital input

7. Info

Display information on device type and firmware versions

ATICS-2-ISO_D00046_04_Q / 10.2019

Submenu

Meaning/ Setting

1. History

Alarm messages and tests which have been performed: value and time

2. Data logger

History of measured values: Line 1, Line 2, position, load current in the TN

system I(3), insulation, transformer load

3. Config. Logger

History of the „Settings" menu: value and time

4. Test logger

History of the tests of the changeover switch carried out

5. Service logger

History of the service activities carried out

1. Changeover

Setting the date and time, system, switching back interlocking function,

preferred supply, generator, test and service interval

2. Voltage

Delay times, voltage ranges, hysteresis

3. Current

Short-circuit detection

4. IT system

Response values insulation, transformer load, temperature, fault location

5. Relay

Mode of operation and relay mode

6. Digital input

Mode of operation, function, delay

7. Data logger

Modify, overwrite, delete

8. Language

Deutsch, English, Francais

9. Interface

Setting the BMS bus address of this device. Allow the settings to be

changed via the interface. Allow a test to be run via interface.

10. Clock

Set date format and date and time

11. Password

Enable resp. set password for settings and test

12. Service

Only for settings to be made by authorised Bender Service personnel

1. TEST

Isometer, changeover, last changeover saved as a test, generator

2.RESET

Reset alarm messages, cancel the switching back interlocking function,

change the alarm value for the max. permissible number of changeover

operations performed and the max. permissible number of operating

hours