BENDIX E-10P DUAL BRAKE VALVES Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch für Kontrolleinheit BENDIX E-10P DUAL BRAKE VALVES herunter. BENDIX E-10P DUAL BRAKE VALVES 8 Seiten. Dual brake valves

Seite drucken

VALVE INSTALLATION

1. Install the assembled brake valve on the vehicle.

2. Reconnect all air lines to the valve using the identiﬁ ca-

tion made during VALVE REMOVAL step 1.

3. After installing the brake valve assembly, perform

the "OPERATION AND LEAKAGE CHECKS" before

placing the vehicle in service.

GENERAL SAFETY GUIDELINES

WARNING! PLEASE READ AND FOLLOW

THESE INSTRUCTIONS TO AVOID PERSONAL

INJURY OR DEATH:

When working on or around a vehicle, the following general

precautions should be observed at all times.

1. Park the vehicle on a level surface, apply the park-

ing brakes, and always block the wheels. Always

wear safety glasses.

2. Stop the engine and remove ignition key when

working under or around the vehicle. When work-

ing in the engine compartment, the engine should

be shut off and the ignition key should be removed.

Where circumstances require that the engine be in

operation, EXTREME CAUTION should be used to

prevent personal injury resulting from contact with

moving, rotating, leaking, heated or electrically

charged components.

3. Do not attempt to install, remove, disassemble or

assemble a component until you have read and

thoroughly understand the recommended proce-

dures. Use only the proper tools and observe all

precautions pertaining to use of those tools.

4. If the work is being performed on the vehicle's air

brake system, or any auxiliary pressurized air sys-

tems, make certain to drain the air pressure from

all reservoirs before beginning ANY work on the

vehicle. If the vehicle is equipped with an AD-IS

air dryer system or a dryer reservoir module, be

sure to drain the purge reservoir.

5. Following the vehicle manufacturer's recommend-

ed procedures, deactivate the electrical system in

a manner that safely removes all electrical power

from the vehicle.

6. Never exceed manufacturer's recommended

pressures.

7. Never connect or disconnect a hose or line

containing pressure; it may whip. Never remove

a component or plug unless you are certain all

system pressure has been depleted.

8. Use only genuine Bendix

components and kits. Replacement hardware,

tubing, hose, ﬁ ttings, etc. must be of equivalent

size, type and strength as original equipment and

be designed speciﬁ cally for such applications and

systems.

9. Components with stripped threads or damaged

parts should be replaced rather than repaired. Do

not attempt repairs requiring machining or weld-

ing unless speciﬁ cally stated and approved by the

vehicle and component manufacturer.

10. Prior to returning the vehicle to service, make

certain all components and systems are restored

to their proper operating condition.

11. For vehicles with Antilock Traction Control (ATC),

the ATC function must be disabled (ATC indicator

lamp should be ON) prior to performing any vehicle

maintenance where one or more wheels on a drive

axle are lifted off the ground and moving.

replacement parts,