BENDIX EC-13 TRAILER ANTILOCK CONTROL Handbuch - Seite 14
Blättern Sie online oder laden Sie pdf Handbuch für Controller BENDIX EC-13 TRAILER ANTILOCK CONTROL herunter. BENDIX EC-13 TRAILER ANTILOCK CONTROL 20 Seiten. Trailer antilock controller assembly
Seite drucken
START HERE
WIRE HARNESS CONNECTOR
1A, 2A
1K, 2K
GROUND
POWER
RESETTING
EC-13
CONTROLLER
MAGNET HERE
CHECKING "VOLT"
LED
ON ?
ON OR FLASHING?
14
Troubleshooting
TESTING FOR POWER TO THE EC-13
TURN IGNITION OFF, DISCONNECT WIRE
HARNESS CONNECTOR FROM EC-13
CONTROLLER
TURN IGNITION ON, MAKE & HOLD A BRAKE
APPLICATION AND, MEASURE VOLTAGE
BETWEEN POWER AND GROUND PINS ON
WIRE HARNESS CONNECTOR
BATTERY VOLTAGE? MUST BE
BETWEEN 8 AND 17 VOLTS.
TURN IGNITION OFF, RECONNECT
WIRE HARNESS TO EC-13
CONTROLLER, TURN IGNITION ON
™
PERFORM A MAGNETIC RESET
BY PASSING A MAGNET OVER THE
"RESET" IN EC-13
DIAGNOSTIC WINDOW THEN
IS THE GREEN, "VOLT" LED
STILL FLASHING OR RED
SECTION IV
1A TO 1K
1A TO 2K
2A TO 1K
2A TO 2K
VOLTAGE SAME AS
YES
™
™
CONTROLLER
REMOVE MAGNET
"ECU" LED STILL ON?
YES
™
REPLACE EC-13
CONTROLLER
™
CONTROLLER
™
RECONNECT CONNECTOR TO EC-13
CONTROLLER. CHECK THE VEHICLE
WIRING FOR CONTINUITY. REFER TO THE
NO
VEHICLE SERVICE MANUAL AND CHECK
THE BATTERY VOLTAGE. REPAIR OR
REPLACE AS NECESSARY AND REPEAT
THE "INITIAL START-UP PROCEDURE"
NO
REPEAT THE
"INITIAL START-UP
PROCEDURE".
™