Bendix CVS SmarTire Trailer-Link TPMS Handbuch zur Schnelleinrichtung

Blättern Sie online oder laden Sie pdf Handbuch zur Schnelleinrichtung für Messgeräte Bendix CVS SmarTire Trailer-Link TPMS herunter. Bendix CVS SmarTire Trailer-Link TPMS 2 Seiten. Tire pressure monitoring system

Seite drucken

SmarTire Trailer-Link

SAFETY

Follow all industry standard maintenance safety precautions, including wearing appropriate eye protection. See the

General Safety Guidelines on the other side.

IMPORTANT

This SmartTire

TPMS kit is pre-programmed and ready to use, subject to your application:

● The sensors have been PRE-ASSIGNED TO WHEEL POSITIONS and are identified on each unit with a position

label (P1, P2, P3, etc.). Install the sensors as per the diagram below.

NOTE:

This Figure

shows wheel

position P1

as a "1" on the

tire symbol,

and so on.

● Default values have been assigned to each axle for the following (depending on kit configuration):

► Cold Inflation Pressure (CIP) – preset to 100 PSI

► First Alert Level (FAL) – preset to ±15% from expected (temperature compensated) value

► Second Alert Level (SAL) – preset to -20% from CIP

► High temperature alert (optional) – 185°F (85°C)

INSTALLATION STEPS:

1. Install the tire sensors in the pre-programmed locations by following "Section B - System Installation – Tire

Sensors" of the SmarTire

2. Follow the instructions in "Section C: System Installation – Components and Programming" to install the bracket,

ECU, (warning lamp if used) and harnesses on the vehicle.

2. Follow the "4.1 Configuring & Customizing Your SmarTire Trailer-Link

system parameters need to be adjusted.

Always replace SmarTire

This page is only a quick set-up guide. For complete installation

instructions, download the SmarTire Trailer-Link

Operator's Manual (BW2920) from the Document Library, or

the Literature Center, at www.bendix.com.

Quick Set-Up Guide

Tire Pressure Monitoring System (TPMS)

™

Recommended

ECU Locations

TPMS Operator's Manual (BW2920).

NOTICE

Tire Pressure Monitoring System fuses with (maximum) 5 amp fuses.

System" section in cases where any

™

TPMS

™