Dymag BOXSTROM Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zubehör für Kraftfahrzeuge Dymag BOXSTROM herunter. Dymag BOXSTROM 11 Seiten. Carbon hybrid automotive wheels

Seite drucken

DYMAG® BOXSTROM™

CARBON HYBRID AUTOMOTIVE WHEELS

OWNERS GUIDE

2.2.

When mounting the tyres the wheels should be clamped externally onto the rim

using rubber protectors on the clamping surface

2.3.

Mount the tyres using only wheel hub support tyre fitting machines being

careful to ensure that the tyre bead is pushed into the wheel well, as the

machine rotates to fit the tyre. Machines that clamp the rim may damage

the rim finish

2.4.

If tyre pressure monitor systems are either bolted directly into the valve hole or

bonded onto the wheels, use caution to not break the sensor when mounting

the tyres

2.5.

Use STICK-ON WEIGHTS ONLY. Clip-on weights can cause damage to the wheels

and their use may void the warranty. To maintain the appearance of your wheels,

weights should be placed inside the wheel barrel not on the outer face of the rim

2.6.

Bolt the wheel lug nuts using the vehicle manufacturer's recommended torque

settings in the vehicle handbook, unless otherwise instructed by Dymag

2.7.

After the wheels and tyres have been fitted to the vehicle, take for a short

test drive

2.8.

Re- check the torque values of each lug nut/bolt and make sure that they are

torqued to the manufacturer's recommended specifications

3. USING YOUR ORIGINAL WHEEL AS A SPARE

If you intend to use one of your original equipment wheels as a spare, make sure that you

keep a set of the correct lug nuts/bolts and a properly sized spanner or wrench in the car

at all times. In most cases, Dymag wheels utilise the original equipment lug nuts/bolts;

however, this may not be true in all cases.

4. TAMPERING WITH WHEEL ASSEMBLY

Under no circumstances should the fastening systems between the rim and centrepiece be

tampered with. Do NOT attempt to tighten or loosen the wheel assembly bolts.

WARNING: TAMPERING WITH THE ASSEMBLY BOLTS WILL AUTOMATICALLY VOID THE

WARRANTY.

5. WHEEL CLEANING

In order to keep your wheels looking like new, regular cleaning is highly recommended

particularly in climates where salt or chemicals are used on the roads or likely to come into

contact with your wheels.

Please follow these wheel cleaning guidelines:

5.1.

Never use any non-water based solvent chemical based cleaners or harsh cleaning

solutions

5.2.

Use only mild soap and water with a soft, non-abrasive brush or cloth rag to clean

the wheels of dirt and debris

5.3.

Spray-on, hose off type cleaners are strictly prohibited

5.4.

Do not clean the wheels when they are still warm from operation of the vehicle.

Allow them to cool before attempting to hose off with water

5.5.

Never use pressure washers for cleaning high performance wheels

5.6.

A soft paste protective wax may be applied to your wheels to ease maintenance

and improve wheel appearance on clear-coated or painted wheels

N.B. Wheels that have not been kept clean, or have incorrect wheel cleaner applied,

will not be covered by warranty.