dymax BlueWave MX-250 Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Industrielle Ausrüstung dymax BlueWave MX-250 herunter. dymax BlueWave MX-250 16 Seiten. Led flood-curing emitter

Seite drucken

Troubleshooting & Maintenance

Problem

BlueWave MX-250

LED does not

produce light

BlueWave MX-250

LED suddenly

stops producing

light

BlueWave MX-250

LED provides only

low-intensity light

U S E R G U I D E

B L U E W A V E M X - 2 5 0 E M I T T E R S

Possible Cause

LED intensity adjustment

set to 0% or too low

LED cycle time is set to

0 seconds

Interlock is open

Interface cable connections

loose or damaged

Trigger setting not

matched to input

LED head is not connected

to the correct port/channel

Over-temperature

shutdown was triggered

Footswitch defective

Interlock is open

LED intensity adjustment

set to minimum

Contaminated/dirty lens

optics

Corrective Action

Increase LED intensity setting.

0 Seconds sets manual mode and

requires a trigger.

Verify interlock jumpers are in place.

Verify PLC command structure for

PLC mode.

Check connections and condition of

interface cable.

Trigger setting on admin screen

should match the desired input trigger

channel.

Verify that the head is connected to the

desired port/channel.

Verify alarms.

Activate unit using the front control

panel. Replace the footswitch if the

unit operates from the front control

panel.

Verify interlock jumpers are in place.

Verify PLC command structure for

PLC mode.

Increase LED intensity setting on

admin settings or I/O input for PLC

mode.

Clean the surface of the lens.