dymax 110 Benutzerhandbuch - Seite 15

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Kontrolleinheit dymax 110 herunter. dymax 110 20 Seiten. Spray valves

NOTE:

Be sure the air holes are lined up on the same face and will align with the

air hole on the Fluid Section (D).

Fluid Section

Screw the Standoffs (G) into the Fluid Section (D) using soft tip pliers to tighten.

Drop the Packing (E) into the Fluid Section (D), and screw in the Packing Nut (F) but

leave finger tight until assembled with the Air Section (M, I).

Mount the 007 Kalrez® O-Ring (V) on the Seat (B) and thread the Seat (B) into the

Fluid Section (D). Tighten using the seat wrench.

Place the Air Cap (A) onto the Fluid Section (D) over the Seat (B) and secure it by

threading the Collar Ring (R) in place.

Assemble Sections

Back out the Stroke Adjuster (O) by turning it counter-clockwise until the end of its

travel.

Apply a small amount of silicone grease to the end of the Needle (C) then insert it

into the Packing Nut (F) and slide the two sections together.

Align the air holes of the Air Section (M, I) on the same face as the atomizing air

hole of the Fluid Section (D) then connect the sections using the two Machine

Screws (Q), tightening them down evenly using a 3/32" Allen key.

Using the tip of a 3/32" Allen key, tighten the Packing Nut (F).

Dymax Model 110 & 210 Spray Valves User Guide