5th Axis R52-V75100X Benutzerhandbuch - Seite 3
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Werkzeuge 5th Axis R52-V75100X herunter. 5th Axis R52-V75100X 8 Seiten. Vise
Seite drucken•
Clean leadscrew with soft brush
•
Use copper based anti-sieze on leadscrew (Loctite P/N: LB8008C5-A)
•
Do not let chips build up during use
•
Do not torque vise past 60 Nm [45 Ft LBS]
•
Do not side load vise (see illustration below)
•
Clamping Force at max torque with Master Jaws installed-22.2 kN [5000 lbf]
•
Weight: 2.72 Kg [5.16 lbs]
Torque Values
•
Jaw Bolts:
•
Mounting Bolts:
•
Lead Screw:
Special Notes
•
Removing leadscrew assembly is not recommended and will void the
warranty
•
Failure to follow these instructions will cause self centering accuracy and/or
repeatability to fail and may cause damage to the vise
•
It is recomended to use only the two outside locating pin holes [LP8] labeled
on page 4 as "A & B"
NO
To Machine Profiles into Soft Jaws/Anti-Lift Soft Jaws:
•
Insert an appropriately sized shim between the jaws
•
Torque to operating torque value
•
Machine profile of part
•
Remove shim and place the part in vise
•
Torque to same value as previous
Following these steps will ensure the highest accuracy
and will compensate for any jaw deflection
in the vise.
Maintenance and Use
27 Nm [20 Ft LBS]-M8x16mm (P/N: 76232)
34 Nm [25 Ft LBS]-M8x40mm (P/N: 76252)
60 Nm [45 Ft LBS] Max
YES
YES
SHIM
Page 3