Gage Bilt GB51 Schnellstart-Handbuch - Seite 3

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Elektrowerkzeug Gage Bilt GB51 herunter. Gage Bilt GB51 8 Seiten. Pneumatic installation tool

Seite drucken

MUST BE UNDERSTOOD TO AVOID

SEVERE PERSONAL INJURY

Do not pull fastener unless it is placed in an

assembly, pin will eject forcibly when pintail breaks

off. Severe personal injury may result.

When operating, repairing or overhauling tool, wear

approved eye protection. Do not look in front of

nose assembly or rear of tool when installing

Keep Nose Assemblies clean and free of chips and

Do not use beyond the design intent.

Tool must be maintained in a safe working

condition at all times and examined on a regular

daily basis for damage or wear. Any repair should

be done by qualified personnel trained on Gage Bilt

procedures.

Where prolonged use is foreseen, it is

recommended a tool balancer be used. Check

suspension device to ensure that it is secure.

Do no use tool in explosive atmosphere.

It is recommended operator wear a suitable glove

during operation where prolonged use is expected.

S/N: 2094 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

SAFETY WARNINGS

PLEASE READ THIS MANUAL BEFORE

SERVICING OR USING THIS TOOL.

WARNINGS:

WARNING

fastener.

CAUTION

debris.

WARNING

Shock:

CAUTIONS:

SHOW CONDITIONS THAT WILL

DAMAGE EQUIPMENT OR STRUCTURE

Always disconnect tool from power before

performing any maintenance to any tool or nose

assembly. Ensure that all connections are proper

and there are no visible leaks from tool or hoses

before connecting to power.

Ensure that nose assembly and tip are properly

matched for the fastener being installed.

Be sure there is adequate clearance for tool and

operator's hands before proceeding. Keep fingers

clear of any moving parts. Keep fingers clear from

fasteners and installed materials. Severe personal

injury may result.

It is required to use hearing protection. A test was

carried out in a simulated work environment where

the background level was 73.2 dB (A). In this

condition the max level was 81.5 dB (A). Therefore,

it is required where prolonged use, hearing

protection be used.

Risk of crushing exists if nose assembly is not

It is recommended tool be operated 50 out of every

60 minutes, where prolonged use is expected.

Tool is not to be used as a hammer.

Air pressure not to exceed 100 psi. (6.9 bar) ,

except where noted.

WARNING

CAUTION

WARNING

attached.

WARNING

Rev 2/14