Gage Bilt GB713 Installationshandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Installationshandbuch für Elektrowerkzeug Gage Bilt GB713 herunter. Gage Bilt GB713 14 Seiten.
Auch für Gage Bilt GB713: Original-Bedienungsanleitung (18 seiten), Original-Bedienungsanleitung (20 seiten)
Seite drucken
HOW TO USE THE GB713
WARNING:
Operator
WARNING:
It is required that eye protection and hearing protection be worn during operation.
WARNING:
Do not pull rivet in the air. Personal injury from fastener ejecting may occur.
WARNING:
Air is exhausted from bottom of the tool. Direct bottom of the tool (exhausted air) away from
operator, other persons working in the vicinity, foreign matter and liquid.
CAUTION:
Do not use beyond design intent.
The tool is shipped with a plastic plug in the air inlet connector. The connector has a 1/4-18 female pipe thread to accept end-user air
hose fitting. The tool comes with oil and is ready to use.
1. Remove plastic shipping plug from Swivel (A-249) and screw in your air fitting.
2. Attach Deflector (704113) to rear of head cylinder assy (713121).
WARNING:
Rotate deflector away from operator and other persons working in the vicinity.
3.
Connect air hose to tool (3/8 minimum diameter air line is mandatory, 90 p.s.i. (6.2 bar) is recommended) and cycle tool a few
times by depressing and releasing air actuator assy (704130). (Clean dry air is recommended.)
WARNING:
Ensure air hose is securely connected to avoid possible hose whipping.
4. Disconnect air hose from tool.
5. Select proper Nose Assembly, screw collet and anvil onto the tool and attach securely. (See proper data sheet for further
instructions.)
6. Connect air supply.
7.
Insert rivet into Nose Assembly and the application then depress air actuator assy (704130). Upon releasing the air actuator assy
(704130), the stem will eject to the rear of the tool.
WARNING:
Always disconnect air supply when tool is not in use to prevent accidental start-up.
MUST
read and understand all warnings and cautions.
CYLINDER
DEFLECTOR
RED
SHIPPING
PLUG
QUICK
DISCONNECT
Image may not reflect actual tool
FITTING
NOSE
HEAD
ASSEMBLY
ASSY
AIR
ACTUATOR
ASSY
5
RIVET
WORK
7/11 REV 10/14