Gage Bilt GB745 Benutzerhandbuch - Seite 9
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Elektrowerkzeug Gage Bilt GB745 herunter. Gage Bilt GB745 13 Seiten. Installation tool
Auch für Gage Bilt GB745: Handbuch (13 seiten)
Seite drucken
HEAD
Remove nose assembly from tool before attempting disassembly of head cylinder (745366).
Remove end cap (745816). Push against threaded end of piston (745310) to slide it out of head cylinder (745366). Be careful not to
damage threads or cause burrs on polished piston rod surface.
WARNING:
Dispose of Hydraulic Oil in accordance with applicable regulations.
The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite® #242 and torque
the four button-head cap screws (402479) uniformly to 40 inch lbs. to prevent leakage around the gasket (745124).
401092 - BACK-UP RING
753101 - NOSE FITTING
480124 - NUT
WARNING
This tool incorporates a patented hydraulic relief valve.
When overhauling tool, o'ring (A-287), back-up ring
(401101), retaining ring (400936) and spring (50806)
must be replaced. Failure to do so could result in
SEVERE PERSONAL INJURY!
GB7045
403815 - O'RING
745366 - HEAD CYLINDER
480101 - PINTAIL TUBE
480125 - RETAINING NUT STOP
405889 - O'RING
745310 - PISTON
401119 - BACK-UP RING
402482 - BUTTON HEAD SCREW (2)
S572 - STAT-O-SEAL (2)
A-261 - O'RING
O'RING - A-287
BACK - UP RING - 401101
SPRING - 50806
RETAINING RING - 400936
9
756120 - DEFLECTOR
A-820 - O'RING
401105 - BACK-UP RING
403846 - O'RING
401119 - BACK-UP RING
PISTON ROD ASSEMBLY - 745344
745816 - END CAP
Rev. 9/14