Dawn AAM2230-00 Installationshandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Installationshandbuch für Inneneinrichtung Dawn AAM2230-00 herunter. Dawn AAM2230-00 6 Seiten. Vanity
Auch für Dawn AAM2230-00: Installationshandbuch (6 seiten), Installationshandbuch (6 seiten)
Seite drucken
IMPORTANT: Recommended for professional installers only. The installer maintains responsibility for installing the product safely.
1. Install the Vanity
Use a stud finder to locate and mark the wall studs.
●
Li and place the vanity cabinet in posi on against the finished wall. Make sure
●
the top is level and the supply valves clear any drawers in the cabinet.
Drill pilot holes through the vanity back and the finished wall. For holes not inline
●
with studs, push or hammer in wall anchors that are made for your wall surface.
Secure the cabinet to the finished wall with screws.
●
2. Install the Countertop
Assemble the faucet and the sink drain to the countertop.
●
Run a bead of silicone adhesive around the top of the vanity cabinet. Place the
●
sink countertop on top of the cabinet and press firmly in place. Let the silicone
adhesive cure.
Connect the water supply lines and the drain.
●
Reinstall the cabinet drawer(s).
●
Apply a bead of caulk along the back edge against the wall. Clean up any excess.
●
Allow 24 hours to dry.
Turn on the water to test for leaks.
●
3. Install the Mirror
Examine the type of brackets on the back of the mirror.
●
Hold the mirror flush and level against the wall in the desired posi on. Mark the
●
mirror's placement with a pencil around the top and bo om corners. Set the
mirror aside with care.
Use a stud finder to locate studs on the wall. Mark the loca on with a pencil.
●
Measure the distance from the top of the mirror to the brackets on the back of
●
the mirror. Use this measurement to mark the posi ons for the screws on the
wall. Make sure the marks are straight with a level.
Drill pilot holes into the marks for the screws . If the screws will not be mounted
●
on studs, hammer in wall anchors.
Insert screws, leaving a short length of screw extending from the wall surface.
●
Hang the mirror.
LEGAL DISCLAIMER:
This instruc on guide is done as a public service to customers of Dawn Kitchen & Bath Products, Inc. ("Dawn"). For special situa ons or further assistance, please consult professionals.
●
All products should be inspected by customers upon receipt and before any installa on. Any defec ve product should be reported immediately and should NOT be installed.
●
Requirements may vary for installa on in a granite, marble, stone, or butcher block countertop.
●
Installa on by professional installers is highly recommended. Dawn assumes no liability for any damages incurred through the use of informa on provided in this guide.
●
INSTALLATION
4
INSTALLATION GUIDE AAMS-4801