Great Circle GUO054 Gebrauchsanweisung - Seite 6

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Chipper Great Circle GUO054 herunter. Great Circle GUO054 17 Seiten. Wood chipper

14. Never allow an adult or anyone under the influence of drugs or alcohol to fill engine.

15. When storing gasoline or equipment with fuel in the tank, store away from furnaces, stoves, water heaters or

other appliances that have a pilot light or other ignition source because they can ignite gasoline vapors.

16. Never fill containers inside a vehicle or on a truck bed with a plastic bed liner. Always place containers on the

ground away from your vehicle before filling.

17. Remove gas-powered equipment from the truck or trailer and refuel it on the ground. If this is not possible, then

refuel such equipment on a trailer with a portable container, rather than from a gasoline dispenser nozzle.

Burns and Fires

The muffler, muffler guard and other parts of the engine become extremely hot during the operation of the

engine.These parts remain extremely hot after the engine has stopped.

Prevention of Burns and Fires

1. Never remove the muffler guard from the engine.

2. Never touch the muffler guard because it is extremely hot and will cause severe burns.

3. Never touch parts of the engine that become hot after operation.

4. Always keep materials and debris away from muffler guard and other hot parts of the engine to avoid fires.

Children and Bystanders

Tragic accidents can occur if the operator is not alert to the presence of children and/or bystanders. Never assume

that others will remain where you last saw them.

1. Keep the area of operation clear of all persons, especially small children and pets. Keep children under the

watchful care of a responsible adult.

2. Be alert and turn the machine off if children enter the area.

3. Before and while moving backwards, look behind and down for small children.

4. Never allow children to operate the machine

ASSEMBLY

1. Install Stand (See Figure 1)

Using four M8*60 bolts (B) and four nuts (C) to tight the stand (A) with the engine base plate (D).

Figure 1