Adelaide Annexe & Canvas Avan Deluxe Installationshandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Installationshandbuch für Zubehör Adelaide Annexe & Canvas Avan Deluxe herunter. Adelaide Annexe & Canvas Avan Deluxe 2 Seiten.
Seite druckenAwning Installation Initial Notes
)
Push roof up as you would when starting erection
process.
)
Marking and fixing of track and brackets is best
done when door side laid horizontally in travel
position.
)
Best reach is either by step ladder and platform
on either side and also by lifting door and stand-
ing inside van. Use whichever position you find
best for each section.
Step 1 (marking tracks)
)
Lay supplied template onto top corner of white
wall (underneath aluminium edging)
)
Carefully draw two very light whiteboard lines as
shown on template
)
This upper line is top of curved rope track section
)
The square line is for top plate and bracket
Step 2 (fitting tracks for awning)
)
Place curved rope track carefully underneath
whiteboard line using small spots of Blu Tack. Po-
sition long side tracks at either end of centre sec-
tion. (pieces should butt together perfectly where
they join and should just touch the aluminium
edging at the bottom. Use Blu Tack on these too.
)
Put up doorway wall and make sure that track
channel sits just below roof capping (make sure
Blue Tack holds). Put wall back down if all OK.
)
Screw track using supplied larger pan head screws
into centre top holes (screw part way for now, do
not screw tight)
)
When happy with this add screws on either side
of joins and at bottom ends of long pieces.
)
With tracks lightly screwed on remove screws and
add a 5mm bead of silicone to underneath of
tracks and carefully place back into position and
then add screws into all pre drilled holes. Screw
down tight without overtightening.
Step 3 (fitting brackets)
)
Peel off backing paper and stick down centre top
bracket plate. Line up holes in a bracket with pre
drilled holes and screw bracket on.
)
Repeat with bottom brackets by positioning as
shown in photos and screw plates and brackets in
place. For each bracket when fitted, remove
screws, add dob of sealant to hole and rescrew.
Step 4 (Cruiseliner and A liner only)
)
Attach new door hook as shown in two photos.
)
Remove screw from existing hook holder and use
for right hand screw of new hook bracket.
Walls Installation Initial Notes
)
Erect camper fully
)
Straight track is at front and bent track is for rear
)
Large pan head screws for track. Smaller self
drilling screws for press studs.
Step 1 (fitting side tracks for walls)
)
Add front (straight) track with channel directly
under left side of bracket slot and 10mm below
wall hinge. Make sure track is vertical and screw
into place.
)
Do the same with tracks on rear but with the
right side of the bracket slot. (bend will allow
miss locker door) Bent at top of reflector, straight
is below
)
Remove screws, add 5mm bead of sealant to
Step 2 (fitting draught skirt)
)
Fit draught skirt using small pan head self drilling
screws.
)
Start by lining door slits evenly under door. Add
door press studs.
)
Add remaining press studs in the following order
(a) either side of door (b) outer corners (c) re-
maining bottom two (d) top wheel arch studs