Hi-Force TWE Series Betriebsanleitung - Seite 14
Blättern Sie online oder laden Sie pdf Betriebsanleitung für Elektrowerkzeug Hi-Force TWE Series herunter. Hi-Force TWE Series 20 Seiten. Electric torque wrench
Seite drucken
Prepared by:-
M.DAVIES
REV NO:-
1
ECO:-
3.4 ERROR MESSAGES
3.4.1 Non-permissible gear change
A gear change is not allowed while the motor is
running. If this is attempted, the bolting process
is interrupted immediately.
The message Err01 flashes in the display for 3
seconds.
Additionally, an acoustic warning signal is
emitted.
The two diode lights flash red alternately. The
message is documented.
3.4.2 Deviating mains voltage
If the mains voltage deviates by ±15%, the
message Err03 flashes in the display for 3
seconds. Bolting process is interrupted.
Additionally, an acoustic warning signal emits.
The two diode lights flash red alternately. The
message is documented.
3.4.3 Deviating mains frequency
The device automatically recognises 50 and
60Hz networks. In case of deviations of the
mains frequency by 50Hz-10% and 60Hz+10%
(45-66Hz) the message Err05 flashes in the
display for 3 seconds.
Additionally, an acoustic warning signal is
emitted.
The two diode lights flash red alternately. The
message is documented.
3.5 SYSTEM ERROR
3.5.1 Error in the speed sensor
If there is any error in speed measurement, the
message Sys01 flashes in the display for 3
seconds.
The bolting process is interrupted.
Additionally, an acoustic warning signal is
emitted.
OPERATING INSTRUCTIONS:
Electric Torque Wrench
Series: TWE
Approved by:-
Page 14 of 20
TDS:-
1399
Date: 25/03/14