Aircommand Sparrow Mk4 Benutzerhandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Klimagerät Aircommand Sparrow Mk4 herunter. Aircommand Sparrow Mk4 17 Seiten. Air conditioning unit
Auch für Aircommand Sparrow Mk4: Handbuch Handbuch (17 seiten)

Seite drucken

Sparrow Mk4 Installation Guide V5

OPERATING INSTRUCTIONS

This appliance is not intended for use by persons (including children) with reduced physical, sensory or

mental capabilities, or lack of experience and knowledge, unless they have been given supervision or

instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised

to ensure that they do not play with the appliance.

OPERATION



Turn the unit on by pressing the ON/OFF button once.



Press the MODE button to cycle through options Cool, Dry, Heat and Fan.



Turn the unit off by pressing the ON/OFF button once more.

COOLING



Cycle mode button to highlight COOL.



You may select High, Med, Low or Auto fan speeds by pressing the fan button. It is recommended that you

choose Auto.



Now select the desired room temperature (herein referred to as SETPOINT) by pressing the TEMP up or down

keys, the readout will flash the set point temperature. Keep pressing the button until it flashes your desired set

point. In approx. 5 seconds the display will resume reading the actual room temperature. The compressor will

have a delayed start usually 3 minutes before unit starts to cool.

Note: Any interruption to the power supply will cause the unit to delay compressor start up.



For simply recirculating air, choose the FAN mode. Choose any of the three fan speeds by pressing FAN.

Note: Temperature button is invalid in Fan only mode.

HEAT



To heat, press MODE button to highlight HEAT.



Select desired set point temperature by pressing TEMP buttons up or down. It is recommended that AUTO fan

speed by selected.



After the delay, the compressor will start. Air will not flow until warm enough. This is to prevent cold draughts.

DRY



The DRY mode is used when the room temperature is close to comfortable but you wish to dehumidify.



Press MODE button to highlight DRY.



Set the temperature to desired set point. Note: the fan speed is locked in LOW.



The compressor will cycle on and off at approximate intervals of 6 minutes to extract moisture from the air.

SLEEP



With the unit operating in cool mode, press SLEEP button to highlight the sleep light. The unit over the next hour

will automatically raise the set point by 1 ˚C. Conversely in heat mode, the set point will be lowered 1˚C.



The TIMER may be used to turn off the unit in the future (up to 24 hours) OR may be used to turn on the unit up

to 24 hours in the future.



Press TIMER button once and the display will flash. Within 3 seconds, press the timer button until you have set

desired time (in hours) into the future to turn unit off. A subsequent press of the timer button will allow the time

to start the unit to be programmed.

LOCKING



This provides a means of locking in the mode and fan settings. To lock, press TEMP DOWN key simultaneously

with MODE button. Hold for 3 seconds and the lock indicator will light. To unlock, repeat above procedure.

DISPLAY SETTING



To change readout from ˚C to ˚F or vice versa: Press TEMP DOWN key simultaneously with the FAN key.

May 2015

Page 14 of 16