Active SmartHome Repeater Installations- und Betriebshandbuch - Seite 11

Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Wiederholer Active SmartHome Repeater herunter. Active SmartHome Repeater 15 Seiten. Active smarthome system

Seite drucken

1. 1. 1. 1.

Under Normal Mode, turn DIP Switch 2 to ON so that the Repeater emits 1 long

beep and the yellow LED flashes (each flash is 1 second).

2. 2. 2. 2.

When the Repeater receives signals from the Active SmartHome Gateway or the

previously installed devices, it will emit a long beep and the blue LED will light

up for one second. The signal is then retransmitted when the red LED flashes

for one second.

3. 3. 3. 3.

To exit the Walk Test Mode, slide DIP Switch 2 to OFF, the Repeater will emit 1

long beep and the yellow LED will fade out.

Ensure the Repeater is at a maximum distance of 20 m from the Active

SmartHome Gateway. By doing this, you will enable your other devices to be

at a maximum distance of 40 m.

3 3 3 3 .4. Mounting the Repeater

.4. Mounting the Repeater

The Repeater can be placed on a table or mounted on a wall. Follow the steps

below to install the device:

1. 1. 1. 1.

Using the holes in the mounting brackets as a template, drill holes into the

mounting surface.

2. 2. 2. 2.

Insert wall plugs if fixing the Repeater into plaster or brick.

3. 3. 3. 3.

Screw the mounting bracket to the wall. Hook the Repeater onto the wall

mounting bracket.

R e p e a t e r

I ns t a l l a t i on a nd O pe ra t i o n G ui d e

P a g e | 1 1