Gaggenau VG 264 AU Einbauanleitung - Seite 3

Blättern Sie online oder laden Sie pdf Einbauanleitung für Kochfeld Gaggenau VG 264 AU herunter. Gaggenau VG 264 AU 4 Seiten.

Seite drucken

Ú Installation instructions

Important notes

Read these instructions carefully and keep them in a safe place.

Safety during use can only be ensured if the appliance is fitted

correctly according to these installation instructions. The

installer is responsible for ensuring that the appliance operates

perfectly at the point of installation.

The appliance must be connected to the mains only by an

authorised person.

Before carrying out any type of work, turn off the electricity and

gas supply.

Statutory regulations

This appliance shall be installed in accordance with the

manufacturer's installation instructions, local gas fitting

regulations, municipal building codes, electrical wiring

regulations and AS/NZS 5601.1 the Australian Standard for gas

installations. Refer also to AS/NZS 5601.1 for pipe sizing tables.

Before connecting the appliance, please check whether the

local connection conditions such as the gas type, gas pressure

and mains voltage and the appliance settings are correct. Refer

to the data plate located on the hob base for the necessary

information.

If the data plate does not agree with the appliance settings refer

to SampfordIXL contact details.

For conversion to another type of gas, please call the after-sales

service.

Risk of gas escape!

After connecting the appliance to the gas supply, always check

the connection for leak tightness. The manufacturer accepts no

responsibility for the escape of gas from a gas connection

which has been previously tampered with.

Ensure sufficient air exchange in the room where the

appliance is installed. Up to 11 kW total output:

Minimum volume of the room where appliance is installed:

■

20 m³

A door leading to the open air or a window which can be

■

opened.

Up to 18 kW total output:

Minimum volume of the room where appliance is installed:

■

2 m³ per kW total output.

A door leading to the open air or a window which can be

■

opened.

An extraction hood into the open air. Minimum displacement

■

volume of extraction hood: 15 m³/h per kW total output.

The plug must remain accessible after installation is complete.

Do not kink or trap the mains connection cable.

The appliance must be fitted according to the installation

drawing.

A minimum clearance of 260 mm from the periphery of the

burner to a rear or side horizontal combustible surface must be

maintained. If clearance is less than 260 mm then that surface

must be non-combustible or be protected in accordance with

AS/NZS 5601.1 clause 6.10.1.2

Overhead clearances

Rangehoods and exhaust fans shall be installed in accordance

with the manufacturers instructions. However, in no case shall

the clearance between the highest part of the burner and the

underside of the rangehood be less than 650 mm or for a

overhead exhaust fan, 750 mm.

This appliance is not intended for operation with an external

timer or an external remote control.

Do not install this appliance on boats or in vehicles.

Preparing the furniture

The surrounding kitchen unit must be heat-resistant to at least

90 °C. The stability of the unit must be maintained after

producing the cut-out.

Produce the cut-out for one or several Vario appliances.

Proceed as shown in the installation sketch. The angle between

the cut surface and the worktop must be 90°.

After producing the cut-out, remove the shavings. Seal the cut

surfaces to make them heat-resistant.

Observe a minimum clearance between the appliance housing

and parts of the unit of 10 mm.

When fitting several Vario appliances: allow for the additional

space required for the connecting strip VV 200. Appliances can

also be fitted in individual recesses, if a minimum clearance of

40 mm between the appliances is observed.