Gaggenau VG 295 AU Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Kochfeld Gaggenau VG 295 AU herunter. Gaggenau VG 295 AU 12 Seiten.

Seite drucken

Soak burnt-in remainders in a little water and

detergent. This loosens even the most stubborn

of soiling. Do not use any abrasive agents and

abrasive sponges.

Only use very little water to clean your cooktop.

Be careful that no water enters the burner base.

As the result of heat development, slight

discoloration can appear on the stainless steel

surface. Do not attempt to scrape away such

discoloration. This damages the surface.

Distribute stainless steel care agents uniformly

and thinly on the cooktop (not on the control

panel!). This will ensure an even surface and will

keep your cooktop in a good condition for a long

period of time.

Make sure the burner parts are dry before

assembly. Only operate the appliance with all

parts dry. Damp burner parts will cause

malfunctions when igniting or unstable flames.

When assembling the burner parts, make sure

that the burner ring and burner head are placed in

such a way that the catching pin fits in the

corresponding groove. Make sure all burner parts

are properly fitted and lie evenly flat.

Important: Fit the middle pot support first (be

careful to center it over the burner) and then the

pot supports on the side. The rounded corners of

the pot supports on the side must face out to the

side. (see picture).

Part/surface

Recommended cleaning method

Stainless steel

Clean with a soft cloth and some soapy

surfaces

water; polish dry with a soft cloth. Do not

use too much water to avoid water enter-

ing the appliance.

Pan support

Carefully take off pan supports for clean-

ing. Soak in soapy water. Clean with a

brush and some detergent.

Be careful when cleaning around the

rubber rests to ensure they do not come

loose.

Rinse with clear water. Carefully dry pan

support before assembly.

Do not clean in a dishwasher!

Part/surface

Recommended cleaning method

Burner lid,

Take burner parts off for cleaning. Clean

burner ring,

in soapy water with a cloth and deter-

burner head

gent. Use brass polish to retain the origi-

(brass)

nal shiny surface of the burner ring and

the burner lid.

Port openings of the burner ring must be

kept free. Be careful not to loose the

small parts.

Do not clean in a dishwasher!

Wok burner

Clean with detergent and brush. Dry

head (enamel

thoroughly before assembly.

on cast iron)

Do not clean in a dishwasher!

Control panel

Clean with a soft, moist cloth and some

soapy water; do not use too much water.

Dry with a soft cloth.

Control knobs

Clean with a soft, moist cloth and some

soapy water; do not use too much water.

Caution! Damage to the appliance: Do

not pull off the control knobs to clean

them.

Cleaning the electrode

Soiled electrodes may cause malfunctions when

igniting or flame monitor disturbance.

If necessary clean with the included brush. Be careful

when cleaning electrodes, they are fragile, do not

twist or damage. Do not switch on the cooktop while

cleaning.

Burnt-in residues

To remove stubborn, burnt-in residues you can order

the grill cleaning gel (order number 00311761) from

your specialist retailer or from our after-sales service.

You can use it to clean the pan supports, the burner

parts and the stainless steel cooktop base. If

necessary apply the gel and leave overnight. Please

observe the manufacturer's instructions.