Gaggenau AT 400 Betriebsanleitung - Seite 13

Blättern Sie online oder laden Sie pdf Betriebsanleitung für Lüftungshaube Gaggenau AT 400 herunter. Gaggenau AT 400 16 Seiten. Table ventilation

Replacing the activated carbon filter

(only for air recirculation mode)

The activated carbon filter in the fan housing (lower

part of the appliance) eliminates smells from the

extracted air. For hygenic reasons, change the

activated carbon filter together with the grease fine

filter at least every six months or when kitchen

smells appear. The activated carbon filter with the

grease fine filter is available from your specialist

dealer. Only use original filters.

Note: If no activated carbon filter is fitted or if it

is saturated, no odours can be removed from the

circulating air.

Disconnect the appliance from the mains

(switch off fuse).

Open the latches on the bottom of the fan

housing. Take off the ventilator lid by pulling the

bottom edge.

Remove activated carbon filter. Insert new

activated carbon filter. The filter mat must lie

flat.

Refit the ventilator lid.

Activated carbon filters do not contain any

polluting substances. They can be disposed of

through the household refuse collection.

The grease fine filter (fleece filter) is fitted behind

the centrifugal grease filters.

Disconnect the appliance from the mains

(switch off fuse).

Tilt the ventilation panel to the rear.

Remove the centrifugal grease filters one by

one (from right to left).

Pull out the grease fine filter from the mounting.

Push the new grease fine filter under the

braces. Refit the centrifugal grease filters in the

reverse order (from left to right).

Grease fine filters do not contain any polluting

substances. They can be disposed of through the

household refuse collection.