2gig Technologies WDQ PAN1345 Installationsanweisungen - Seite 2

Blättern Sie online oder laden Sie pdf Installationsanweisungen für Sicherheitssystem 2gig Technologies WDQ PAN1345 herunter. 2gig Technologies WDQ PAN1345 2 Seiten. Panic button remote

Seite drucken

Testing

Before mounting the sensor, ensure that the sensor mounting location provides good RF communication to the panel. To verify, do the

following:

From the Installer Toolbox on the control panel, select walk test.

Press and hold the panic button on the remote for approximately 2 seconds. The LED will light up for approximately 1 second to confirm a

signal has been sent.

Listen for the voice descriptor on the control panel to announce "panic remote."

From the Installer Toolbox press ok to exit sensor test mode.Inserting and Replacing Batteries

Under normal conditions the battery can last up to 2 years. If the battery is low the trouble

notification will be indicated on the control panel's screen. Use only the recommended replacement

batteries (see Specifications). Users need to perform a system test at least once a year.

Remove the top cover by inserting a small flathead screwdriver into the slot located on the bottom

right corner and twist.

Place a small flathead screwdriver in the slot between the metal clip and battery and twist the

screwdriver slightly while holding back one of the black plastic edges holding the battery.

Insert the replacement battery with the + sign facing out.

If the circuit board is removed, ensure the LED is aligned with its hole.

Verify programming and RF communication with the panel (see Programming).

Replace the sensor cover.

WARNING:

The polarity of the battery must be observed, as shown. Improper handling of lithium

batteries may result in heat generation, explosion or fire, resulting in personal injuries. Replace only

with the same or equivalent type of battery as recommended by the manufacturer (see

Specifications). Batteries must not be recharged, disassembled or disposed of in fire. Disposal of

used batteries must be made in accordance with the waste recovery and recycling regulations in

your area. Keep Away From Small Children. If batteries are swallowed, promptly seek medical

attention. 

California Only: This Perchlorate warning applies only to Manganese Dioxide Lithium cells sold or

distributed ONLY in /California, U.S.A. Perchlorate Material‐special handling may apply. See

dtsc.ca.gov/hazardouswaste/perchlorate.

Specifications

Wireless Signal Range

Code Outputs

Transmitter Frequency

Transmitter Frequency Tolerance

Transmitter Bandwidth

Modulation Type

Unique ID Codes

Supervisory Interval

Peak Field Strength

Sensor Type

Dimensions (L x W x H)

Weight (including battery and bracket)

Housing Material

Color

Operating temperature

Relative Humidity

Battery (included, not installed)

Regulatory Listings

Included Accessories

FCC and Industry Canada Regulatory information

This device complies with Part 15 of the FCC's Rules. Operation is subject to the following two conditions. (1) This device may not cause

harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

This product complies with FCC radiation exposure limits for an uncontrolled environment. Avoid operating this product at a distance less than

20cm from the user.

Caution: Any changed or modifications not expressly approved by the party responsible for compliance could void the user's authority to

operate this equipment.

This 2GIG Technologies product is warranted against defects in material and workmanship for 2 years. This warranty extends only to wholesale

customers who buy direct from 2GIG Technologies or through 2GIG Technologies' normal distribution channels. 2GIG Technologies does not

warrant this product to consumers. Consumers should inquire from their selling dealer as to the nature of the dealer's warranty, if any.

There are no obligations or liabilities on the part of 2GIG Technologies for consequential damages arising out of or in connection with use or

performance of this product or other indirect damages with respect to loss of property, revenue, or profit, or cost of removal, installation, or

reinstallation. All implied warranties for functionality, are valid only until the warranty expires. This 2GIG Technologies Warranty is in lieu of all

other warranties express or implied.

All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact 2GIG Technologies at 1(866)670‐

1591 for an RPA# and other important details.

Warranty service return address:

350 ft., open air, with Wireless Alarm Control Panel

Alarm; Supervisory; Low Battery

345.000 MHz (crystal controlled)

± 15kHz

24 kHz

Amplitude Shift Keying On/Off Keying (ASK‐OOK)

Over one (1) million different code combinations

70 minutes

Typical 36,000 uV/m at 3m

Red (when activated)

1.65 x 1.20 x 0.50 in. (4.19 x 3.05 x 1.27 cm)

0.45 oz. (12.8 g)

ABS plastic

White with grey button

32° to 120° F (0° to 49° C)

Water resistant

1 Panasonic CR123A, or equivalent Lithium battery

ETL, FCC Part 15, Industry Canada

Lanyard, wristband, belt clip, multi‐functional clip, wall mount

LIMITED WARRANTY

2GIG Technologies, Inc.

2961 W Maple Loop Drive

Lehi, Utah 84043

Technical Support Contact Information

1‐855‐244‐4832

Email: [email protected]

Internet: dealer.2gig.com

PN 187‐0735 Rev D