Dynabrade 52573 Betriebshandbuch

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Werkzeuge Dynabrade 52573 herunter. Dynabrade 52573 8 Seiten. 1hp 4" cut-off tool

Seite drucken

1Hp 4" Cut-Off Tool

Governor Controlled

Models:

52573 – 15,000 RPM

52574 – 18,000 RPM

52575 – 20,000 RPM

Read and understand this tool manual before operating your air tool. Follow all safety rules for the protection of operating person-

nel as well as adjacent areas. Always operate, inspect and maintain this tool in accordance with the American National Safety

Institute (ANSI) Safety Code for Portable Air Tools – B186.1. For additional safety information, refer to Safety Requirements for the

Use, Care and Protection of Abrasive Wheels – ANSI B7.1, Code of Federal Regulation – CFR 29 Part 1910, European Committee for

Standards (EN) Hand Held Non-Electric Power Tools – Safety Requirements and applicable State and Local Regulations.

Read and understand tool manual to reduce risk

of injury to operator, visitors, and tool.

Eye protection must be worn at all times, eye

protection to conform to ANSI Z87.1.

Respiratory protection to be used when exposed

to contaminants that exceed the applicable

threshold limit values required by law.

Carefully Read all instructions before operating or servicing any Dynabrade

Products offered by Dynabrade are not to be modified, converted or otherwise altered from the original design without expressed written consent from Dynabrade, Inc.

Tool Intent: Abrasive Cut-Off Tools are ideal for cutting off all types of materials, metals and steel, including stainless and steel alloys.

Training: Proper care, maintenance, and storage of your tool will maximize its performance.

• Employer's Responsibility – Provide cut-off tool operators with safety instructions and training for safe use of tools and accessories.

Accessory Selection:

• DO NOT use – non-reinforced cut-off wheels.

• Abrasive/accessory RPM (speed) rating MUST be approved for AT LEAST the tool RPM rating.

• Before mounting an accessory, visually inspect for defects. Do not use defective accessories.

• Mount only recommended accessories. See back page of manual and Dynabrade catalog.

• Follow tool specifications before choosing size and type of accessory.

• Only use recommended fittings and air line sizes. Air supply hoses and air hose assemblies must have a minimum working pressure rating of 150 PSIG (10 bars, g) or 150

percent of the maximum pressure produced in the system, whichever is higher. (See tool Machine Specifications table.)

Warning: Always wear eye protection. Operator of tool is responsible for following: accepted eye, face, respiratory, hearing and body protection.

Always use wheel guard. Make sure it is positioned to best protect the operator and make sure it is securely fastened. Wheel guards that have been subject to a

wheel breaking must be replaced.

Air Tool Manual – Safety, Operation and Maintenance

SAVE THIS DOCUMENT, EDUCATE ALL PERSONNEL

WARNING

SAFETY LEGEND

WARNING

SAFETY INSTRUCTIONS

Do Not Use Tool For Anything Other Than Its Intended Applications.

OPERATING INSTRUCTIONS

(Continued on next page)

Practice safety requirements. Work alert,

have proper attire, and do not operate tools under

the influence of alcohol or drugs.

Ear protection to be worn when exposure to sound,

exceeds the limits of applicable Federal, State or

local statues, ordinances and/or regulations.

Air line hazard, pressurized supply lines and flexible

hoses can cause serious injury. Do not use dam-

aged, frayed or deteriorated air hoses and fittings.

Abrasive Power Tool.

Parts Page Reorder No. PD01•82

Effective September, 2001

WARNING